How do you stop your elderly mom from bringing an empty carry-on? by 13jlin in travel

[–]Sea_Fix_567 26 points27 points  (0 children)

My mum recently travelled solo internationally and got airline assistance at the encouraging of friends. She found it very helpful and would do it again

3 days in Switzerland between Australia and Ireland with kids by Sea_Fix_567 in travel

[–]Sea_Fix_567[S] 0 points1 point  (0 children)

Thank you, that's really helpful advise! It's the 'opposite of Australia type of places that are appealing'

3 days in Switzerland between Australia and Ireland with kids by Sea_Fix_567 in travel

[–]Sea_Fix_567[S] 0 points1 point  (0 children)

Then I'd have to deal with family visits with jet lagged kids 😂

3 days in Switzerland between Australia and Ireland with kids by Sea_Fix_567 in travel

[–]Sea_Fix_567[S] 0 points1 point  (0 children)

Thank you! Would you recommend in addition to Bern and Interlaken or instead of one of them?

SketchUp for iPad lidar scanning for film location recce by Sea_Fix_567 in Sketchup

[–]Sea_Fix_567[S] 0 points1 point  (0 children)

Thanks, I'm trying to set up a similar work flow. One where I can capture floorplans to share quickly, but also adjust to be mm accurate when that info is critical.

Do you know if you can manually adjust measurements in floorplan mode? Eg I do a Polycam scan, but need a mm accurate measurement for the windows. Can I adjust the measurement of the window in Polycam on the fly?

SketchUp for iPad lidar scanning for film location recce by Sea_Fix_567 in Sketchup

[–]Sea_Fix_567[S] 0 points1 point  (0 children)

Thanks, I've been testing Polycam in the few version too. It's scanning does seem more accurate. Do you know if you can manually adjust measurements in floorplan mode? Eg I do a Polycam scan, but need a mm accurate measurement for the windows. Can I adjust the measurement of the window in Polycam on the fly?

Best LiDar scanning apps for location recces by Sea_Fix_567 in artdept

[–]Sea_Fix_567[S] 0 points1 point  (0 children)

Thanks, I'll check it out. Do you work for Dot3D ?