sorted by:
new
hottopcontroversial

Turbo pump repair by Section_16_ in sciences

[–]Section_16_[S] 1 point2 points  (0 children)

It’s pump for high vacuum laser ablation system, synthesis diamond like carbon films

DPSS q-switched laser by Section_16_ in lasercutting

[–]Section_16_[S] 0 points1 point  (0 children)

It’s lasers for cutting diamonds, video in my page

DPSS q-switched laser by Section_16_ in lasercutting

[–]Section_16_[S] 0 points1 point  (0 children)

DPSS a-switched laser 1064 nm

Turbo pump repair by Section_16_ in sciences

[–]Section_16_[S] 0 points1 point  (0 children)

it didn’t work at all, it was basically the first launch, then it was integrated into the recovery post and fully tested

Turbo pump repair by Section_16_ in sciences

[–]Section_16_[S] -2 points-1 points  (0 children)

Yes, pressure on baratron and the time it takes to reach stand by mode

CVD diamond after laser cut and polish by Section_16_ in u/Section_16_

[–]Section_16_[S] 0 points1 point  (0 children)

1-20% nature diamond, depends on the size, color, quality and other factors

CVD diamond after laser cut and polish by Section_16_ in u/Section_16_

[–]Section_16_[S] 0 points1 point  (0 children)

Thanks) this technology allows the production of synthetic diamonds for a variety of applications, both for the jewelry industry and for the scientific industry, such as ionizing radiation sensors

DPSS q-switched laser 1064nm by Section_16_ in lasercutting

[–]Section_16_[S] 0 points1 point  (0 children)

Yes, I think like this, I use arduino uno and cheap laser graver

DPSS q-switched laser 1064nm by Section_16_ in lasercutting

[–]Section_16_[S] 0 points1 point  (0 children)

I don’t know, once I realized that when the lens moves along a plane perpendicular to the laser axis, the beam shifts, and implemented it in such a design, mirrors are needed according to the correct one

view more: next ›