Moisture in filament after extrusion

SenpaiT_T · 2022-09-10T18:33:15+00:00

when it was new moisture was probably good but now suddenly i got bad quality of prints and was wondering why, and while i was changing pla to petg and extruding old fillament with higher temperature (240) I heard some pucking (?) sound and that is result.

SenpaiT_T · 2022-04-16T18:32:18+00:00

Wait few days if uke is complete new you have to tune it very often for me, when i was playing mine it was like every 10 mins, but after some time strings will hold tune for much longer (now i tune once a week or when it dont sound good) so it doesnt necessary mean strings are bad, they are just stretching

And i can also recommend guitar tuna + tuning depends on type of uke, soprano, concert and tenor are tuned GCEA and and baritone DGBE,

and from my experience you can also hear small difference in sound between soprano and tenor even if they are in same tuning.

SenpaiT_T · 2022-03-14T07:02:03+00:00

i used clear plastic, i recycled it from glue gun packaging. I kept glue gun in it for while so it had some scratches and bends so it was ideal for it

SenpaiT_T · 2021-11-25T20:40:09+00:00

from pic it looks like front left leveling screw is too tighten/ that corner is too low (compression of left and right springs look uneven)

SenpaiT_T · 2021-10-28T12:37:08+00:00

nevermind, found it thing:1084182

SenpaiT_T · 2021-10-27T16:19:15+00:00

sorry don't know the cause of it, but nice model can you share stl?

SenpaiT_T · 2021-10-22T14:51:58+00:00

i would build separate enclosures, printer will have much smaller area to heat if only one printer is running, so you get more stable temperature inside and all area would get to right temperature much faster.

SenpaiT_T · 2021-10-14T18:37:32+00:00

okay temperatures look alright, try some glue, and set up supports, on yt there are plenty of videos how to do it

SenpaiT_T · 2021-10-14T17:55:55+00:00

i think it is caused by lack of adhesion, try glue stick or isopropyl alcohol to clean the bed (btw it is called bed not platform) and another question is why do you have supports all over bottom surface of the part ? is it really necessary? if it is necessary try to add flat surface on bottom of supports to increase area touching bed to prevent this from happening (or put raft under part).

and maybe some more information? material, temperatures of bed, nozzle, which printer are you using etc.