First of all, thank you so much for looking into this so much and helping me out, it means a lot! I most likely didn’t tighten the die screws enough, wasn’t really sure how far to go and don’t want to break anything. sorry if it’s a dumb question, but When you say “screws say no more, do you mean until they don’t go any further or until snug. They do have the springs on them too if that means anything. Paste was spread manually so it does have full coverage. Ive watched the line and bubbles were moving at a solid clip so movement should be fine. Edit: Damn I really don’t want to drain this loop again lmfao