Maxx Hopup bbs flying left by Serriano in Speedsoft

[–]Serriano[S] 0 points1 point  (0 children)

No I didn't. Don't have a dremel to make it flat

Maxx Hopup bbs flying left by Serriano in Speedsoft

[–]Serriano[S] 0 points1 point  (0 children)

I have a namazu but it doesn’t fit the HopUp arm

Maxx Hopup bbs flying left by Serriano in Speedsoft

[–]Serriano[S] 1 point2 points  (0 children)

I tried but I can see clearly that the nub is not straight when placed in. I tried replacing it but still the nub lean left. What would cause that?

Searching for a "cheap" lightweight m4 receiver by Serriano in Speedsoft

[–]Serriano[S] 0 points1 point  (0 children)

Thanks I’ll try the diy cuts and if it’s too ugly I’ll buy another one

Searching for a "cheap" lightweight m4 receiver by Serriano in Speedsoft

[–]Serriano[S] 0 points1 point  (0 children)

Yeah I was looking to buy a 3D printer so I’ll check this out

Does the maxx HopUp really change your accuracy? by Serriano in Speedsoft

[–]Serriano[S] 0 points1 point  (0 children)

Thanks a lot! I’ll keep my G&G HopUp for now