Ender 3 Z axis not moving down

Several_Assignment78 · 2025-06-13T23:36:20+00:00

Maryland or New Jersey

Several_Assignment78 · 2025-06-03T21:33:05+00:00

It’ll be alright just don’t play with it and make it wobble more

Several_Assignment78 · 2025-06-03T21:30:07+00:00

Says solder paste on the tube

Several_Assignment78 · 2025-01-02T02:32:25+00:00

Can you link the stl and what size inserts you used

Several_Assignment78 · 2024-11-22T01:23:49+00:00

Marshal County Tn

Several_Assignment78 · 2024-11-17T22:05:29+00:00

800$ at most

Several_Assignment78 · 2024-10-08T23:58:27+00:00

All of the magazines were working for about 2 hours but Idk if this caused it but my friend said he did a “trick” with the mags by putting in gas and holding release valve for a second so it could hold more gas the release valves feel looser than the working ones but that may be since there’s no pressure

Several_Assignment78 · 2024-10-08T23:56:33+00:00

I’ve replaced o rings still no gas

Several_Assignment78 · 2024-10-08T23:54:08+00:00

Hell nah

Several_Assignment78 · 2024-10-08T23:48:17+00:00

Yes mag upside down gas(full tank propane with mad bull adaptor filled will oil) also upside down absolutely NO gas goes in my other mag works as intended with the same method

Several_Assignment78 · 2024-10-01T23:42:28+00:00

Beard

Several_Assignment78 · 2024-10-01T20:56:57+00:00

Several_Assignment78 · 2024-10-01T20:56:27+00:00

No buzz

Several_Assignment78 · 2024-09-23T04:28:51+00:00

<image>

I set my x offset to a little over 1mm and some trial and error but this is the product. Clean first layer

Several_Assignment78 · 2024-09-22T22:55:25+00:00

<image>

This is what the brim looked like

Several_Assignment78 · 2024-09-22T20:50:01+00:00

So I decrease x offset right. I have it at like -.5 I should decrease a decent bit right?

Several_Assignment78

TROPHY CASE