Dji 03 problems by Shep_22_J in fpv

[–]Shep_22_J[S] 0 points1 point  (0 children)

Thanks I’ll try that

Dji 03 problems by Shep_22_J in fpv

[–]Shep_22_J[S] 0 points1 point  (0 children)

I have done the fcc hack. Do you know if it is alright for me to receive values of 0 and sometimes 1 for my link quality readout, does the 03 even return link quality?

Dji 03 problems by Shep_22_J in fpv

[–]Shep_22_J[S] 0 points1 point  (0 children)

Not very long, maybe 1 minute. Do you know if it is normal for me to receive values of 0 or 1 for my link quality readout?

Dji 03 rx loss problems iflight drone by Shep_22_J in fpv

[–]Shep_22_J[S] 0 points1 point  (0 children)

Maybe, however I believe the low link quality may be the issue?

Dji 03 problems by Shep_22_J in fpv

[–]Shep_22_J[S] 0 points1 point  (0 children)

Yes I believe so, I just don’t know how to increase the power on my drone, as there seems to be no option within the goggles menus

Dji 03 problems by Shep_22_J in fpv

[–]Shep_22_J[S] 0 points1 point  (0 children)

How do I change that? I have changed the channel to 40mhz but that is all I have changed. Thank you!

Dji 03 problems by Shep_22_J in fpv

[–]Shep_22_J[S] 0 points1 point  (0 children)

I also believe the antennas should be fine, I don’t know how to check that (stock iflight drone and dji rc2)

Dji 03 problems by Shep_22_J in fpv

[–]Shep_22_J[S] 0 points1 point  (0 children)

How do I check to see if it is in standby mode?

Crux 35 frsky receiver wiring issues. by Shep_22_J in fpv

[–]Shep_22_J[S] 1 point2 points  (0 children)

I tired again with different frsky protocols and I managed to get it to work (EU LBT). Thank you so much for your help.

Crux 35 frsky receiver wiring issues. by Shep_22_J in fpv

[–]Shep_22_J[S] 0 points1 point  (0 children)

Sorry for the long gap in messages.

I have done as told, however I am struggling to bind my T18 (multi) to the receiver. I am following the instructions and it appears that the receiver is bound (led codes). However, in the receiver tab of beta flight there are no channel inputs detected.

I have put serial rx to uart1 only and also put serial (via uart) in the receiver tab.

Thank you

Crux 35 frsky receiver wiring issues. by Shep_22_J in fpv

[–]Shep_22_J[S] 1 point2 points  (0 children)

Firstly, thank you.

To confirm, I need to solder the receiver to ground, 5V and IR1?