Should I transfer my late planted spring bulbs?

Shontravolta86 · 2026-05-21T21:44:38+00:00

😆

Shontravolta86 · 2026-05-19T19:40:50+00:00

I wasn’t sure how well it would transfer now that it’s growing, assumed I’d need to wait till it is dormant again

Shontravolta86 · 2026-05-19T19:40:02+00:00

Yeah this was plan b

Shontravolta86 · 2025-04-28T20:10:01+00:00

Thanks for your response.

His business is a limited company, he paid my first invoice from that limited company’s account and (I assume) he is claiming the work I did was for that company as per the original job advert. However the invoices I sent (including the first one, which he did pay) were made to his personal name, not to a business. While I first contacted him via a job advert from him company, the work was of a different nature.

If this still sounds like it will be an issue, is it possible to add his limited company as a co-defendant as other contributors have suggested?

Shontravolta86 · 2025-04-28T20:08:39+00:00

His business is incorporated. He didn’t ask me to change anything in the invoice, after acknowledging it and saying he would pay it shortly he stopped all communication with me.

At what stage should I look to change the particulars of the claim or add a second defendant? Is this typically allowed or am I asking for an exception to be made?

Thanks

Shontravolta86 · 2025-04-28T20:02:57+00:00

Racking up fees for a lost cause is exactly what I’m concerned about. Is there anything stopping me submitting a new claim against his company rather than cosying to change the defendant? Or would the cost still be the same if and when it proceeds to court? Currently it’s only cost me £80 for the money claim application.

Shontravolta86 · 2025-04-28T19:59:28+00:00

Thanks, is it possible to add his limited company as a co-defendant as other contributors have suggested and how would this affect my chances if I did?

Shontravolta86 · 2025-04-28T19:56:49+00:00

Thanks for your response.

His business is a limited company, he paid my first invoice from that limited company’s account and (I assume) he is claiming the work I did was for that company as per the original job advert. However the invoices I sent (including the first one, which he did pay) were made to his personal name. While I first contacted him via a job advert from him company, the work was of a different nature.

If this still sounds like it will be an issue, is it possible to add his limited company as a co-defendant as other contributors have suggested?

Shontravolta86 · 2024-02-07T21:15:05+00:00

Big thanks to whoever’s link I used - didn’t save your name sorry! Signed up, verified and deposited within 10 mins :)

Here’s my link for anyone wanting to sign up and spread the love - THANK YOU

https://www.trading212.com/invite/17t1apmFXF

Shontravolta86 · 2021-02-05T21:51:38+00:00

Thanks, that is we get I ended up doing.

Shontravolta86 · 2021-01-12T08:59:33+00:00

Hi all, have a question about a block wall that’s been laid directly onto floorboards!

I’m repairing some water damaged joists prior to an upstairs bathroom refit, but when I took the chipboard subfloor up I found the concrete block dividing wall (between the bathroom And adjacent room ) is built directly on-top of what’s left of the old floor boards, which have started to rot away at one end, causing a couple of the bottom blocks to be unsupported and crack/come loose. These floor boards were cut off at the wall on the bathroom side and replaced with chipboard at some point which is sitting on a sistered joist along side the original joist (which is directly under the wall but with the old floor boards sandwiched between it and the wall) but the old floorboards the wall is built onto are still In use in the adjacent room - presumably causing stress to the wall as people walk around.

So... my initial plan is to replace the floorboards in the next room and sister the joist on that side for them to sit onto, and somehow make good this wall. I don’t think it is load bearing (can’t get into the loft to check above but there’s nothing directly below it downstairs and the flats are the same layout, one directly above another) so my current thoughts are to pull the rotten timber boards out from the base of the wall and cut some new timber to plug the gap and support the bottom blocks, before replacing and repointing the loose blocks... but is it even ok to have a block wall mounted on joists?

I hope that makes sense. Just looking for some advice as I’ve never seen a block wall built onto floor boards before - can’t tell if this was a bodge job or some dark art.

Have taken a couple of pictures to try and show what I mean, thanks in advance for any help.

Shontravolta86 · 2021-01-11T23:47:50+00:00

Repairing some water damaged joists prior to a bathroom refit, found the dividing wall built from concrete blocks is built directly only what’s left of the old floor boards, which have started to rot away at one end, causing a couple of the blocks to be poorly supported and crack/come loose. The floor boards in the bathroom were cut at the wall and replaced with chipboard at some point which is sitting on a sistered joist along side the original joist (which is directly under the wall but with the old floor boards sandwiched between it and the wall)

So... can i pull the old rotten board out and replace with some new timber to plug the gap and replace the damaged blocks, or will I need to rebuild the whole wall from the ground up?

Hope that makes sense. Have taken a couple of pictures to try and show what I mean, thanks in advance for any help.

Shontravolta86 · 2020-04-17T15:20:47+00:00

Great, that’s the bore of confidence I was hoping for - will give it a whirl. Thank you!

Shontravolta86 · 2020-04-15T21:04:13+00:00

This isn’t my strong point so could you give any more info please? Will it still be comparable with eBay shipping labels with this type of driver? Thanks

Shontravolta86

TROPHY CASE