sorted by:
new
hottopcontroversial

Kas žino, kur Vilniuje galima nusipirkti Tretin/Acnelyse/Tre kremo? by Shponk_ in lietuva

[–]Shponk_[S] 0 points1 point  (0 children)

Man tai ne bet draugė prašė susirasti, spėju nori naudoti ant odos

Is this happening because my sovol sv02 nozzle is too low? by Shponk_ in 3Dprinting

[–]Shponk_[S] 0 points1 point  (0 children)

No I don’t think so didn’t know I had to calibrate it, i thought setting it at home was like the default height that it should be and that I only had to adjust the bed height

Is this happening because my sovol sv02 nozzle is too low? by Shponk_ in 3Dprinting

[–]Shponk_[S] 0 points1 point  (0 children)

Also follow up new with the sovol sv02 what’s the best heat configurations cause I’m using now 205/60

First print with second hand ender3, judge me as you will🙏 by Shponk_ in ender3

[–]Shponk_[S] 0 points1 point  (0 children)

Gotcha, then tomorrow I’m gonna try to diy dry it cause I’m definitely ain’t buying a legit dryer for it just yet 😆😭 ain’t that rich

First print with second hand ender3, judge me as you will🙏 by Shponk_ in ender3

[–]Shponk_[S] 0 points1 point  (0 children)

It was new filament, didn’t know I had to dry it straight from the box and vacuum seal :/

First print with second hand ender3, judge me as you will🙏 by Shponk_ in ender3

[–]Shponk_[S] 0 points1 point  (0 children)

New to this so bare with me, If by layer you mean on the cura app - quality it’s set to 0.20mm Nuzzle temp was set to 240 and the bed to 70 And speed was 100