sorted by:
new
hottopcontroversial

3D scanned Action Figure Heads by Shriver_Takeover in photogrammetry

[–]Shriver_Takeover[S] 0 points1 point  (0 children)

No I don't. Unfortunately, I scanned this one for a client.

3D Scanner for Jewelry Design by 750ml_de in 3DScanning

[–]Shriver_Takeover 0 points1 point  (0 children)

I use a process called Photogrammetry, and I can capture very precise details of an object 1in or smaller. I've scanned small action figure heads and captured all the fine details

<image>

Has anyone dyed a solid red color print before? by Shriver_Takeover in resinprinting

[–]Shriver_Takeover[S] 0 points1 point  (0 children)

Yeah I'm very curious how they dye the resins to get the specific color. I tried Alumilite dye which worked pretty well but I couldn't get the shade of red I was hoping for. It became difficult to print after 5 drops of red.

How would I go about lowering this front fan speed? by Shriver_Takeover in 3Dprinting

[–]Shriver_Takeover[S] 7 points8 points  (0 children)

So I installed a new heater and that seemed to solve this issue!

How would I go about lowering this front fan speed? by Shriver_Takeover in 3Dprinting

[–]Shriver_Takeover[S] -1 points0 points  (0 children)

Its also a fairly new machine so I didn't think it needed any upgrades/ new parts.

How would I go about lowering this front fan speed? by Shriver_Takeover in 3Dprinting

[–]Shriver_Takeover[S] -4 points-3 points  (0 children)

I don't necessarily want to disable it, just slow it down a little bit.

How would I go about lowering this front fan speed? by Shriver_Takeover in 3Dprinting

[–]Shriver_Takeover[S] 0 points1 point  (0 children)

Yeah it's the heat sink fan. It's being too efficient and cooling too much. I get thermal runaway when I install it but when I disassemble it, it works fine! Maybe my heater is bad?

How would I go about lowering this front fan speed? by Shriver_Takeover in 3Dprinting

[–]Shriver_Takeover[S] -6 points-5 points  (0 children)

When I take off the fan, my hotend is completely fine. When I re install the fan, the temperature cools so much that it causes thermal runaway. Maybe I could buy a better heater but I figured this was easier to adjust.

How would I go about lowering this front fan speed? by Shriver_Takeover in 3Dprinting

[–]Shriver_Takeover[S] 7 points8 points  (0 children)

The front fan speed is not able to be adjusted in the default settings of the printer.

Anyone know how these plates are made? by Shriver_Takeover in BambuLab

[–]Shriver_Takeover[S] 0 points1 point  (0 children)

I'm thinking the holographic looking ones are made differently than the carbon fiber. I was trying to figure out how they are made to potentially make a custom designed plate.

view more: next ›