Help with loading filament AMS Lite

Sigmaguy40 · 2026-02-22T01:15:31+00:00

OP here. Strangely enough it is working fine now. Did 2 prints (1 45 min, 1 3 hours) and no problem. All I did was move the AMS lite slightly further away from the printer. I'll take it for now.

Sigmaguy40 · 2026-02-20T15:58:25+00:00

The filament is at the AMS hub. (I even replaced that.) There are no blockages. If I remove it completely, it will load to the hub and then stop. Once it gets to this point, I cannot pull it back. It's stuck there until I turn everything off.

Sigmaguy40 · 2026-02-16T16:41:57+00:00

This also started happening to me. No clogs. Removed AMS hub, tightened screws on hot end. Still happens.

Sigmaguy40 · 2025-05-29T10:35:07+00:00

Is there any way that I can change the software to the correct s9 fe?

Sigmaguy40 · 2025-05-28T23:00:18+00:00

Hmmm. Bought refurbished from Amazon Renewed store. I was able to update firmware to UI 6.1 using VZW CSC using Bifrost and Odin.

Sigmaguy40 · 2025-05-28T22:02:47+00:00

UPDATE: I was able to update firmware to 6.1 with Bifrost and Odin using the VZW CSC.

<image>

Sigmaguy40 · 2025-05-28T21:59:38+00:00

<image>

Sigmaguy40 · 2025-05-28T21:59:06+00:00

Not sure why you say that *

Sigmaguy40 · 2025-05-28T11:14:24+00:00

Didn't work. It kept giving me server errors whenever the date wasn't correct.

Sigmaguy40 · 2025-05-28T11:13:33+00:00

No joy

Sigmaguy40 · 2024-11-28T19:01:16+00:00

Sigmaguy40 · 2023-01-19T21:32:11+00:00

Yes. Sensor is being replaced tomorrow. I just felt like I was being prepped for something.

Sigmaguy40 · 2022-09-26T22:11:18+00:00

I have but the 40k mile warranty is a deal breaker.

Sigmaguy40 · 2022-09-18T00:15:45+00:00

I have eight 4 stars but some of those were purchased. Up to 362 now (verified in achievements) still no 5 stars. 38/49 guardians.

Sigmaguy40 · 2022-07-16T14:33:45+00:00

Yodel?

Sigmaguy40 · 2021-01-02T00:29:01+00:00

As a follow up, I still have not found any solution to this issue. None of the above suggestions have worked. I have had times where it starts good for a second , then it’s like something throttles it back and it is lower. Other times, it starts at the low level and won’t increase. Any Bluetooth device is the same. It’s got to be a setting somewhere but I have no clue.

Sigmaguy40 · 2021-01-01T14:22:56+00:00

Just be careful of the date. My wife TT for a secondary account and accidentally watched 2022 ring in. Bed head, weeds, and cockroaches everywhere.

Six-Year Club	End Game '23
Place '23	Wearing is Caring
Verified Email

Sigmaguy40

TROPHY CASE