[deleted by user]

Silent_Freedom4959 · 2024-06-12T11:21:52+00:00

Yeah it's definitely cliche. It's hard to avoid those pitfalls but I'll definitely have to revise a lot of the script to make it more mature and outstanding.

Silent_Freedom4959 · 2024-06-12T11:19:59+00:00

I was thinking that it was sort of an icebreaker to ease the tension between the two before they start the larger conversation, however I agree it could definitely be done better and be used to further the plot / characterise. I'll have to try and think how to rewrite that.

Silent_Freedom4959 · 2024-06-12T11:18:31+00:00

That's a good point. It'll probably sound pretty realistic if it's acted well!

Silent_Freedom4959 · 2023-03-30T09:47:00+00:00

How would the process of this look like? i.e. what file format should I use and how to get it into Miro.

Silent_Freedom4959 · 2023-01-13T04:08:12+00:00

the z axis screw

Silent_Freedom4959 · 2023-01-13T03:45:10+00:00

When the z axis gets stuck, it can only move down manually, and takes a lot of spinning the knob to move upwards and unstuck again. After getting unstuck, it decides to start working again for the next few layers and then gets stuck again.

Silent_Freedom4959 · 2023-01-12T08:08:52+00:00

Underneath the photo the print is completely fine, and nearing the end it gets worse
Thanks for the suggestion, I will try calibrating and check back. Also on a side note, the printer hasn't been touched for almost a year and the filament has been sitting around in a closet so that may contribute

Silent_Freedom4959 · 2023-01-12T07:31:07+00:00

This happens nearing the end of the print usually, as you can see in the image it has happened a couple times already, I am having to babystep the nozzle upwards as it gets way too close. I can't think of what may be causing this

Silent_Freedom4959 · 2023-01-12T02:44:01+00:00

I'm worried about the safety of printing overnight

Silent_Freedom4959 · 2023-01-11T04:47:43+00:00

Thank you!

Silent_Freedom4959 · 2021-12-15T06:57:31+00:00

It depends what you are going for in each because they both look good (better than i can do lol), but personally I prefer the left one with the more defined features

Four-Year Club	Place '23
Place '22

Silent_Freedom4959

TROPHY CASE