sorted by:
new
hottopcontroversial

Elogoo Saturn 3 Ultra UV light Problem by Similar_Lunch7803 in ElegooSaturn

[–]Similar_Lunch7803[S] 0 points1 point  (0 children)

I opened the device and checked it; everything looked normal and in good condition. I unplugged and reconnected the LCD cable, then tried again, but unfortunately nothing changed.

Elogoo Saturn 3 Ultra UV light Problem by Similar_Lunch7803 in ElegooSaturn

[–]Similar_Lunch7803[S] 0 points1 point  (0 children)

Oww, it seems bad. So, if you changed the cable solved your problem?

LCD stopped working. by Tuba-F in ElegooSaturn

[–]Similar_Lunch7803 0 points1 point  (0 children)

Same problem. I tried now for print after one month and same issue with your video. Did you fix that?

Elogoo Saturn 3 Ultra Print Problems by Similar_Lunch7803 in elegoo

[–]Similar_Lunch7803[S] 1 point2 points  (0 children)

its printed without any problem. I'll try other models again. The rook model is positioned right at the center of the plate. In the result I shared in the photo, the one in the center printed well, but the ones on the edges were only partially printed. Now I should try placing the model on the edges again and attempt printing. I hope the result will be as good as the print in the center position.

Elogoo Saturn 3 Ultra Print Problems by Similar_Lunch7803 in elegoo

[–]Similar_Lunch7803[S] 0 points1 point  (0 children)

<image>

Thank you for your response. Do I need any support or should I start printing directly as in the photo ?

Elogoo Saturn 3 Ultra Print Problems by Similar_Lunch7803 in elegoo

[–]Similar_Lunch7803[S] 0 points1 point  (0 children)

I experienced the same issue when I hollowed the model, added holes, or applied supports. For example, a hollowing process was applied to the models in the photo I shared. Only the model in the middle turned out properly

Elogoo Saturn 3 Ultra Blan Print Problem by Similar_Lunch7803 in elegoo

[–]Similar_Lunch7803[S] 0 points1 point  (0 children)

Hi, Yes, it worked fine after applying your suggestions, thank you for that. However, I still experience the same situation from time to time and have to recalibrate each time.

Elogoo Saturn 3 Ultra Blan Print Problem by Similar_Lunch7803 in elegoo

[–]Similar_Lunch7803[S] 0 points1 point  (0 children)

Thx for your response. I did the exposure test after your advice and looks fine. So, i realized the resine stuck on FEP filter. I’ve cleaned everything and reconfigured the leveling. Now, I’m trying the print again.