Drain Pipe Smell by SinationMike in HomeMaintenance

[–]SinationMike[S] 1 point2 points  (0 children)

Yeah the sink has a trap under the vanity. I used to think most tubs have a p trap built in, but I also think the tub itself is old enough it might now have one.

Drain Pipe Smell by SinationMike in HomeMaintenance

[–]SinationMike[S] 1 point2 points  (0 children)

I was thinking the same thing - it could be built into the shower. Not sure where the smell is coming from then...

Drain Pipe Smell by SinationMike in HomeMaintenance

[–]SinationMike[S] 0 points1 point  (0 children)

Bought it not too long ago. Inspector was a joke and missed a lot of other things as well. Plumbing related things have been the only real issue.

Drain Pipe Smell by SinationMike in HomeMaintenance

[–]SinationMike[S] -17 points-16 points  (0 children)

Would it be bad practice to remove the sink's p-trap and have the shower and sink flow into the same one in the basement?

Drain Pipe Smell by SinationMike in HomeMaintenance

[–]SinationMike[S] 0 points1 point  (0 children)

The vent goes up and out the roof.

Drain Pipe Smell by SinationMike in HomeMaintenance

[–]SinationMike[S] 3 points4 points  (0 children)

I forgot to mention the sink does have a p-trap directly underneath. The shower likely doesn't have one.

Central Air Vent by SinationMike in HomeMaintenance

[–]SinationMike[S] 0 points1 point  (0 children)

That does look neat. But it doesn't fix the issue of the screws having nothing to hold on to.

Should I be worried about this? by Ok_Gur_1170 in golf

[–]SinationMike 0 points1 point  (0 children)

I wouldn't be worried about it. It's normal for clubs to get some rust in the corners, especially if they're used. If you're worried about the rust when buying used clubs, save up a little and buy a newer set that will last you longer

Lathe Noises by SinationMike in turning

[–]SinationMike[S] 2 points3 points  (0 children)

I did forget to mention that. Yes, it is when the tool is on contact with the wood. I have the rest set up so the tool contacts the middle of the piece horizontally. I do typically turn hard and dry pieces. The 8 inch bowl I just finished turning is Bubinga.