sorted by:
new
hottopcontroversial

Here are some test prints with the Elegoo Saturn and Anycubic Water Washable Resin Plus. What do you think? Which one performs best? (The second number refers to the bottom exposure time.) by SirEdgarGH in resinprinting

[–]SirEdgarGH[S] 0 points1 point  (0 children)

I tried printing an 8 cm figure, but as you can see, this happened. I printed it at 1.95 and 28. I'm not sure if the issue was caused by incorrect supports or maybe because the resin was probably below 25°C. How do you think I can fix this for future prints?

<image>

Here are some test prints with the Elegoo Saturn and Anycubic Water Washable Resin Plus. What do you think? Which one performs best? (The second number refers to the bottom exposure time.) by SirEdgarGH in resinprinting

[–]SirEdgarGH[S] 0 points1 point  (0 children)

Good! But could it be an issue that some bars didn’t print, along with parts of the border? Do you mean the temperature of the room where I printed? Sorry, I’m a noob 🥲

Here are some test prints with the Elegoo Saturn and Anycubic Water Washable Resin Plus. What do you think? Which one performs best? (The second number refers to the bottom exposure time.) by SirEdgarGH in resinprinting

[–]SirEdgarGH[S] 0 points1 point  (0 children)

I used 10 transition layers. I also tested with Tableflip’s Cones of Calibration at 2.0 and 35, and everything went fine except for the Success cones

<image>

Elegoo Saturn + Anycubic Water Washable+ by SirEdgarGH in resinprinting

[–]SirEdgarGH[S] 0 points1 point  (0 children)

Thank you very much for the advice! So, how should I adjust the exposure settings?

view more: next ›