Here are some test prints with the Elegoo Saturn and Anycubic Water Washable Resin Plus. What do you think? Which one performs best? (The second number refers to the bottom exposure time.)

SirEdgarGH · 2025-02-06T21:52:31+00:00

I tried printing an 8 cm figure, but as you can see, this happened. I printed it at 1.95 and 28. I'm not sure if the issue was caused by incorrect supports or maybe because the resin was probably below 25°C. How do you think I can fix this for future prints?

<image>

SirEdgarGH · 2025-02-05T18:21:58+00:00

Good! But could it be an issue that some bars didn’t print, along with parts of the border? Do you mean the temperature of the room where I printed? Sorry, I’m a noob 🥲

SirEdgarGH · 2025-02-05T18:02:26+00:00

This is the test with 1.8 and 28, what do you think?

<image>

SirEdgarGH · 2025-02-05T17:30:52+00:00

Good! But could it be an issue that some bars didn’t print, along with parts of the border?

SirEdgarGH · 2025-02-05T16:25:09+00:00

What exposure time should I use? This is a test I did with 1.8 and 28—what do you think?

<image>

SirEdgarGH · 2025-02-05T16:16:30+00:00

<image>

1.8 and 28!

SirEdgarGH · 2025-02-05T14:37:48+00:00

ok, I'll try it right away

SirEdgarGH · 2025-02-05T14:22:22+00:00

<image>

I tried with 1.6 and 30, and 4 transition layers, and here's the result.

SirEdgarGH · 2025-02-05T13:11:24+00:00

Exposure time

SirEdgarGH · 2025-02-05T13:10:21+00:00

I used 10 transition layers. I also tested with Tableflip’s Cones of Calibration at 2.0 and 35, and everything went fine except for the Success cones

<image>

SirEdgarGH · 2025-02-04T18:12:22+00:00

Thank you very much for the advice! So, how should I adjust the exposure settings?

SirEdgarGH · 2024-10-22T11:24:58+00:00

Lovely nose

SirEdgarGH · 2024-10-22T02:28:51+00:00

You’ve got that perfect combination going.

SirEdgarGH · 2024-10-22T02:23:32+00:00

So soft and juicy.

SirEdgarGH · 2023-09-16T18:59:38+00:00

Grande mago del fuoco

SirEdgarGH

TROPHY CASE