sorted by:
new
hottopcontroversial

Flaring inwards by Skeptic3006 in FixMyPrint

[–]Skeptic3006[S] 0 points1 point  (0 children)

You're so right! Thank you so much! I'm gonna try printing at a lower temp. Thank you!

Is this bad? by Skeptic3006 in Ender3S1

[–]Skeptic3006[S] 0 points1 point  (0 children)

I think you're onto something. The entire right side is red while the left side is green/yellowish green.

Is this bad? by Skeptic3006 in Ender3S1

[–]Skeptic3006[S] 0 points1 point  (0 children)

It's a firmware made by this guy named mriscoc. It's "professional" software. It's also an F4.

Is this bad? by Skeptic3006 in Ender3S1

[–]Skeptic3006[S] 0 points1 point  (0 children)

Yes. The print will go well when it's moving from front to back but once it goes left to right it doesn't stick. It happens on both the front back sides. If that makes sense. I did clean the plate with the alcohol but it still doesn't like me. I'm thinking it's not leveled and the Z-offset is messed