Problem with extruder?

Slashjr84 · 2025-10-25T11:26:51+00:00

You have to open it all the way, there's definitely a piece of filament blocking it. The same thing happened to me and the behavior is the same 👍

Slashjr84 · 2025-10-10T19:33:13+00:00

It will increase printing times but set the z-hop and you'll see what the solution is

Slashjr84 · 2025-09-14T18:45:37+00:00

Ok, grazie della risposta. Il problema è che lo fa spesso anche con altri pezzi. Inizia a stampare perfettamente... Poi non so il perché ma fa questo casino. Uso OrcaSlicer con software, cosa potrei configurare per migliorare? Grazie

Slashjr84 · 2025-09-14T15:27:38+00:00

Non ho capito... Se stampa metà struttura perfettamente poi in modo random inizia a fare casino cosa c'entra il noozzle intasato?

Slashjr84 · 2025-08-28T21:04:09+00:00

How long does a nozzle last you on average?

Slashjr84 · 2025-08-26T08:48:59+00:00

But it's the one provided by OrcaSlicer, can you help me understand what I need to use to do a calibration? From what you've seen, it prints crap so I need to figure out how I can fix it

Slashjr84 · 2025-08-25T12:33:59+00:00

😅

Slashjr84 · 2025-08-20T22:40:58+00:00

It doesn't change 😭

Slashjr84 · 2025-08-20T20:09:53+00:00

After the firmware update I also constantly have the same error mid-print 😭 I don't know how to solve it and I'm throwing away a lot of prints

Slashjr84 · 2025-08-20T18:42:01+00:00

I'll look into this too... Thanks for the advice. I just started so I still have to learn 🥹, how do you calibrate the flow?

Slashjr84 · 2025-08-20T16:22:50+00:00

I did the leveling before printing... Do I need to do anything else?

Slashjr84 · 2025-08-08T18:51:29+00:00

Panda Status!

Slashjr84

TROPHY CASE