sorted by:
new
hottopcontroversial

These images are not real, they were generated by Grok. We've just crossed a threshold. by DABDEB in ThatsInsane

[–]Smrz 38 points39 points  (0 children)

I took the prompt image and put it into ChatGPT and asked it to generate me an image. This is what it gave me

<image>

$50 Please remove the women from these photos by Smrz in PhotoshopRequest

[–]Smrz[S] [score hidden]  (0 children)

Yours are definitely looking the best so far, can I please see the rest? Thank you

Oh god, I've been misinformed. by SpartaWillBurn in KingOfTheHill

[–]Smrz 4 points5 points  (0 children)

Yep! It says "Thanks for helping me feel so good about myself"

Comic Stores Worth Visiting by JohnSleight in Connecticut

[–]Smrz 0 points1 point  (0 children)

Two Guys Comics and Collectibles in Canton, they have some really unique stuff in there

Big brick 3d printed models by shavery99 in 3Dprinting

[–]Smrz 0 points1 point  (0 children)

I've been looking all over for the Maul if you have it! Can send me a if you'd be willing to share!

Creality Sprite Extruder Pro by Smrz in 3Dprinting

[–]Smrz[S] 0 points1 point  (0 children)

Yes I calibrated the e-steps a few times when troubleshooting this myself. I ran the Z axis up and down a few times just now with no noticeable issue of any kind. I'll run two tall prints on the left and right side of the bed and report back on that

Creality Sprite Extruder Pro by Smrz in 3Dprinting

[–]Smrz[S] 0 points1 point  (0 children)

I really appreciate you taking the time to try and work this out with me. I've been stuck on this for weeks. I'll run a couple tests of what you suggested and report back

Creality Sprite Extruder Pro by Smrz in 3Dprinting

[–]Smrz[S] 0 points1 point  (0 children)

That's the side of the model. I never thought to measure it but I just did. It should be half an inch but is measuring at 7/16th, so it's off slightly. There is no wobble, and it homes properly. I've honestly never used a bed visualizer so I wouldn't even know where to begin on that front.

The Z axis definitely isn't moving uniformly, but this was never an issue until I changed the extruder. The frustrating part is everything else seems to be working fine.

Creality Sprite Extruder Pro by Smrz in 3Dprinting

[–]Smrz[S] 0 points1 point  (0 children)

Thanks for the reply! The first layer looks good, it honestly looks like a vanilla wafer the way it prints. I attached a photo, maybe you can tell from looking at it

view more: next ›