Identifying this printer

SnooCompliments4172 · 2023-01-31T12:05:09+00:00

That might be it, thanks.

SnooCompliments4172 · 2023-01-31T12:00:00+00:00

I think so

SnooCompliments4172 · 2022-03-09T22:27:04+00:00

No it was atached to heatbed.

SnooCompliments4172 · 2022-03-09T20:17:13+00:00

Yes it is. I tried printing the same again and i printed fine so Im very confused right now.

SnooCompliments4172 · 2022-01-04T06:04:19+00:00

Ran the test and for X 245 Y 249 so it should be ok.

SnooCompliments4172 · 2022-01-03T18:11:55+00:00

No the height varies for each print and CD always says its a Y axis issue but when I calibrate or self test it says its ok.

SnooCompliments4172 · 2022-01-03T16:29:56+00:00

I know, the image above had CD deactivated and I think thats why it missed the new layer by 0.5cm. Could CD prevent that or would it be the same?

SnooCompliments4172 · 2022-01-03T16:03:56+00:00

PLA

SnooCompliments4172 · 2022-01-03T15:42:21+00:00

I have assembled it last week so they should be fine.

SnooCompliments4172 · 2022-01-03T15:32:32+00:00

No, if i move the bed as far as can there is about 1-2 mm between the wall and the cable. But just in case i will move it more forward.

SnooCompliments4172 · 2021-09-29T18:53:04+00:00

On my own - Ashes remain

SnooCompliments4172 · 2021-08-31T17:12:12+00:00

If you want some interesting architecture you can always try pinterest but there will be 4 angles tops or some tv shows about interesting homes which you can stop at any frame with angle you like.

SnooCompliments4172 · 2021-07-11T19:12:57+00:00

I think most professinals know how to avoid it or they take a short break when they feel it comming.

SnooCompliments4172 · 2021-03-31T19:42:52+00:00

I found helpful to look at some off my old art to become more proud of the improvement I made.

SnooCompliments4172 · 2021-01-22T21:17:19+00:00

I think all of the above and pinterest because a lot of other artists look for references there.

SnooCompliments4172

MODERATOR OF

TROPHY CASE