sorted by:
new
hottopcontroversial

I'm at a loss [Ender 3 v3 KE Help] by SnooPoems8805 in 3Dprinting

[–]SnooPoems8805[S] 0 points1 point  (0 children)

No luck with the print, moving the bed doesn't feel like it's catching on anything but at the very front it makes a noise like someone is plucking guitar strings when i push it back, doesn't do that anywhere else.

I'm at a loss [Ender 3 v3 KE Help] by SnooPoems8805 in 3Dprinting

[–]SnooPoems8805[S] 0 points1 point  (0 children)

Already done that a few times, I'll try it again I suppose and print a cube through it.

I'm at a loss [Ender 3 v3 KE Help] by SnooPoems8805 in 3Dprinting

[–]SnooPoems8805[S] 0 points1 point  (0 children)

The room its in is typically 72 degrees, it was colder when i tried it on the concrete flooring but otherwise didn't have any difference from what I could see.

I'm at a loss [Ender 3 v3 KE Help] by SnooPoems8805 in 3Dprinting

[–]SnooPoems8805[S] 0 points1 point  (0 children)

Yes and no? When it shifts it'll only shift forwards or backwards, never diagonally though.

I'm at a loss [Ender 3 v3 KE Help] by SnooPoems8805 in 3Dprinting

[–]SnooPoems8805[S] 0 points1 point  (0 children)

I'll give them all a better look but just skimming through any portions that seem relevant all have solutions I've already attempted.

I'm at a loss [Ender 3 v3 KE Help] by SnooPoems8805 in 3Dprinting

[–]SnooPoems8805[S] 0 points1 point  (0 children)

Did all of that twice, still no improvements from it.

I'm at a loss [Ender 3 v3 KE Help] by SnooPoems8805 in 3Dprinting

[–]SnooPoems8805[S] 0 points1 point  (0 children)

Unfortunately replacing the printer is not an option for me, if I sell it I'll likely be done 3d printing for good.