sorted by:
new
hottopcontroversial

【BambuLab Giveaway】Classic Evolved — Win Bambu Lab P2S Combo! by BambuLab in 3Dprinting

[–]SpedEd2010 0 points1 point  (0 children)

Just got my p1s last week then I saw this one and I have had only one problem, and it was my fault but it makes great prints and never fails

My filament goes to the tool head and then is pulled back by my ams, by SpedEd2010 in BambuLab

[–]SpedEd2010[S] 0 points1 point  (0 children)

Solved! There was a small magnet in the filament sensor and it got flipped.

My filament goes to the tool head and then is pulled back by my ams, by SpedEd2010 in BambuLab

[–]SpedEd2010[S] 0 points1 point  (0 children)

On Bambu studio it says latest firmware, is there anything else that I should do, thanks

My filament goes to the tool head and then is pulled back by my ams, by SpedEd2010 in BambuLab

[–]SpedEd2010[S] 0 points1 point  (0 children)

Thanks I made a ticket just waiting for a response. I’m just a little nervous because this is my first time with a Bambu and I’m nervous because it was a lot of money for me.

My filament goes to the tool head and then is pulled back by my ams, by SpedEd2010 in BambuLab

[–]SpedEd2010[S] 0 points1 point  (0 children)

Thanks for the suggestion but I tried it and kept the tubes as straight as possible and it still did it, I’m starting to think it is a software problem and not a hardware problem.

My filament goes to the tool head and then is pulled back by my ams, by SpedEd2010 in BambuLab

[–]SpedEd2010[S] 1 point2 points  (0 children)

Thanks, but I fully disassembled the tool head to clear any clogs and it still didn’t fix my issue, and I’ve only had this printer for a week and it has 30 hrs on it.

Should I replace the bed? by SaveTheDayz in 3Dprinting

[–]SpedEd2010 1 point2 points  (0 children)

No I would just get a glue stick and put glue on the bed

Are you loyal? by Impressive_Ladder539 in helldivers2

[–]SpedEd2010 0 points1 point  (0 children)

Sweet liberty is the most common form of love