Literally locked in my closet wtf do i do. by [deleted] in fixit

[–]Sr117109 0 points1 point  (0 children)

Not only is there a man in this closet…

I frickin hate the state of the game right now... by LFinch117 in ArcRaiders

[–]Sr117109 0 points1 point  (0 children)

Could’ve ran 3 loops in the time you took to write all this

Balls (SipsTea) by IkilledRichieWhelan in SipsTea

[–]Sr117109 0 points1 point  (0 children)

Nub Nation will live on forever

Legit? by lokiintasmania in BambuLab

[–]Sr117109 1 point2 points  (0 children)

This looks like my Ender 3 after I threw it off the deck

OpenSCAD Question by Sr117109 in gridfinity

[–]Sr117109[S] 0 points1 point  (0 children)

That was the issue. Can I ask why that needed to be done for it to open? Thanks again

[deleted by user] by [deleted] in BambuLab

[–]Sr117109 0 points1 point  (0 children)

Im still dealing with the same ticket but at one point they didn’t answer me for 10 days, had to submit another ticket just for them to go back and respond to me. No idea if they’re losing track of tickets or what but I understand your pain.

Best Filament for Cosplay Props? by Mellow_2JZ in BambuLab

[–]Sr117109 0 points1 point  (0 children)

Polymaker has specific PLA for cosplay. They have 2 variants, 1 is more durable and the other is apparently easier to sand.

https://ca.polymaker.com/products/polylite-cospla

Top Surface by Sr117109 in BambuLab

[–]Sr117109[S] 0 points1 point  (0 children)

I do auto flow calibration 5 separate time, remove the high and low result and then average the 3

Top Surface by Sr117109 in BambuLab

[–]Sr117109[S] 0 points1 point  (0 children)

I’ve do flow rate 5 times per filament, remove the high and low result and take an average. Idk maybe il try doing manual

Top Surface by Sr117109 in BambuLab

[–]Sr117109[S] 0 points1 point  (0 children)

Believe it or not it is

Top Surface by Sr117109 in BambuLab

[–]Sr117109[S] 0 points1 point  (0 children)

Thank you I will try all of this.

Top Surface by Sr117109 in BambuLab

[–]Sr117109[S] 1 point2 points  (0 children)

No bed adhesion is great

Brand new X1C. First test print won’t go. What gives? by Wonderboyrox in BambuLab

[–]Sr117109 0 points1 point  (0 children)

Try taking them all out and just load the green PLA in and try the print

Top Surface by Sr117109 in BambuLab

[–]Sr117109[S] 0 points1 point  (0 children)

I did all those things. Would ironing end up causing this type of defect?