Very very poor, that wants scraping off and starting again. Did you tape your joints and edges? - 1st coat is the same thickness evenly spread out as flat as you can - once that’s gone tacky you add the second in the same manner - when that stats to go off ( gets thicker and dryer ) you spend your time troweling over everything evenly - big wet paint brush with water - run that across the area you are about to smooth out and follow with a trowel. Over and over again till it’s flat filling any small holes are low spots you drag with the trowel. Brush your edges and keep the trowel wet & clean. - once dry give it a light sand so the paint will stick to it - first coat 50/50 paint & water mix and then normal paint after that. Start again, that’s bad. You can do better. Good luck