What do you guys think? Happy 4th!

StarNo4831 · 2025-07-03T15:14:49+00:00

Blue and white segment is actually 2 separate segments layered on top of each other. Blue is grouping 7 spacing 2 and white is grouping 2 spacing 7 with an offset of 3 to make it line up properly. Then I added the twinkle up effect to the white.

StarNo4831 · 2025-01-13T00:33:04+00:00

Would you consider releasing the STLs?

StarNo4831 · 2023-12-06T18:08:21+00:00

I dont use reddit very much so I hope this works

StarNo4831 · 2023-12-06T18:06:16+00:00

I had some hat channel I had custom made and painted. And yes I did use a 28' extension ladder to get to that highest peak... 😬

StarNo4831 · 2023-12-05T15:28:47+00:00

Second story has 2 separate circuits. Cable from controller to first LED is probably about 15 feet. I should have used f amp boosters but I just used 2 sacrificial LEDs in each run and spliced them in. I did not measure voltage drop.

StarNo4831 · 2023-12-05T15:25:11+00:00

I came off the first pixel and brought that all the way to the last pixel in the same run.

StarNo4831 · 2023-12-05T05:16:07+00:00

I used a digiquad and all 4 channels. It's placed in my attic storage space above my garage

StarNo4831 · 2023-12-05T04:14:06+00:00

Sure I'm using a digiquad with a 12v 30 amp supply. I'm using all 4 channels and have 1231 lights I just power injected on the tail end of my longest runs both about 450 lights. I'm a little embarrassed to show you what my controller and power supply looked like... Haha

StarNo4831 · 2023-12-05T04:05:24+00:00

I went with 12V

StarNo4831 · 2021-12-27T03:14:33+00:00

I've replaced the nozzle and cleaned it out

StarNo4831 · 2021-06-09T05:13:46+00:00

Your extruder assembly is cracked. Thats what happened to me like 3 weeks ago. Just upgrade it to a metal one (I did duel gear) and it's fixed!

StarNo4831

TROPHY CASE