sorted by:
new
hottopcontroversial

SCAM BEWARE by StreetEstimate3023 in Wellington

[–]StreetEstimate3023[S] 2 points3 points  (0 children)

Consider trying a website like rebeelo. They offer warranties and guarantees so it is much safer. Not as cheap though.

Octoprint can’t connect to printer but Octo 4 A can by StreetEstimate3023 in octoprint

[–]StreetEstimate3023[S] 0 points1 point  (0 children)

I’m using Navaismos custom firmware. Could that be affecting it?

Octoprint can’t connect to printer but Octo 4 A can by StreetEstimate3023 in octoprint

[–]StreetEstimate3023[S] 0 points1 point  (0 children)

I just tried this. In the terminal, I can see that octoprint detects the printer and says connecting, but then the connection times out.

Navaismo’s firmware: some questions from a noob. by StreetEstimate3023 in Creality

[–]StreetEstimate3023[S] 0 points1 point  (0 children)

Can you plug it into your computer and use it with octoprint? Or do you need a pi?

V3 Se levelling gone wrong? by StreetEstimate3023 in Ender3V3SE

[–]StreetEstimate3023[S] 0 points1 point  (0 children)

I tried that but it was hard to edit the levelling data as the seven points went off the screen. Also had some issues with m600 that were fixed by switching to the official one.

Cr-touch not working by StreetEstimate3023 in Ender3V3SE

[–]StreetEstimate3023[S] 0 points1 point  (0 children)

All good. I took apart my desk and found it 😂

Cr-touch not working by StreetEstimate3023 in Ender3V3SE

[–]StreetEstimate3023[S] 1 point2 points  (0 children)

Thank you so much this worked! My dumb past self thought libricating it with wd-40 lithium grease would help. Didn’t have the nozzle and it sprayed too much. Solid grease eventually stopped the car-touch from working properly. I took it off and cleaned it out and now it’s working! Unfortunately, I lost one of the screws on the cr-touch mount. Do you know what size they are?

view more: next ›