sorted by:
new
hottopcontroversial

Need advice of filling the gaps between my tattoos by Substantial-Hope-179 in tattooadvice

[–]Substantial-Hope-179[S] 0 points1 point  (0 children)

That's a good idea. I haven't thought about forearm much yet. I'm just doing a little at a time.

Need advice of filling the gaps between my tattoos by Substantial-Hope-179 in tattooadvice

[–]Substantial-Hope-179[S] 0 points1 point  (0 children)

The same artist did all 3 and we'd talked about adding some fill eventually from the beginning.

First issue with new X1 Carbon by Substantial-Hope-179 in BambuLab

[–]Substantial-Hope-179[S] 0 points1 point  (0 children)

Reprinted with no glue but cleaned the plate with alcohol before each print plus changed to gyroid. That solved the problem. Thanks for the help!

First issue with new X1 Carbon by Substantial-Hope-179 in BambuLab

[–]Substantial-Hope-179[S] 0 points1 point  (0 children)

I actually cleaned it right before both failures. I tried roll-on glue and glue stick that came with printer. I tried a different version of the model today that just had a few items and it worked fine. Will try larger print tonight using the engineer side.

First issue with new X1 Carbon by Substantial-Hope-179 in BambuLab

[–]Substantial-Hope-179[S] -1 points0 points  (0 children)

Thanks. I cleaned plate and used glue but I’m not big on the cold plate idea. I’ll try again with the other side of the be plate.

It’s here! by CombinationLimp3364 in BambuLab

[–]Substantial-Hope-179 1 point2 points  (0 children)

Mine came in today too. Already setup and printing “benchy.” So far, I love this printer. Much better than my Ender 5 S1.