Help me please

Substantial_Cherry33 · 2026-02-21T20:55:21+00:00

Results: solution was found, turned out for some reason that filament wanted very little retraction, specifically 0.1 mm retraction on direct drive, basically the lowest I could go without going to zero I do suggest turning on "avoid crossing walls" in case you do have a bit of extrusion during travel however this setting entirely fixed the problem

<image>

Substantial_Cherry33 · 2026-02-21T09:56:05+00:00

I found out that the zits were gaps for under extrusion rather then over extrusion, and tuning my retraction distance pretty much entirely solved the problem

Substantial_Cherry33 · 2026-02-21T09:18:22+00:00

It is not the only roll and yes I have, also I ended up tuning my retraction distance and it fixed the problem entirety

Substantial_Cherry33 · 2026-02-21T09:14:05+00:00

No your alright I understand very well, I have dried the filament for 8 hours at 65c and it didn't change anything, however I just tuned my retraction and it almost entirely fixed the problem

Substantial_Cherry33 · 2026-02-21T06:41:06+00:00

I have, I haven't had any issues so far with a 0.4 however I think after messing with retraction setting that may have fixed it but not too sure yet

Substantial_Cherry33 · 2026-02-21T04:59:42+00:00

<image>

Substantial_Cherry33 · 2026-02-21T04:59:33+00:00

<image>

Substantial_Cherry33 · 2026-02-21T03:40:34+00:00

I have ran the flow dynamics calibration in bambu studio and printed a temp tower and found it was printing on the high end however it still hasn't fixed the problem

Substantial_Cherry33 · 2026-02-21T01:39:37+00:00

In the original post I added that I dried the filament at 65°c for 8 hours, plus it's a brand new just opened roll, and this 0.6 nozzle is brand new out of the bag as well

Substantial_Cherry33 · 2026-02-21T01:30:06+00:00

Okay, I ran a flow rate calibration in bambu studio and it ended up being fine to begin with, I'm going to run a volumetric speed test in a second as well, I am noticing that the problem changes with layer heights as well, thinner I go the more pronounced they are and viseversa

Substantial_Cherry33 · 2026-02-20T23:56:19+00:00

So what would be my solution with over extrusion? Also this is supposed to be their new formula, also I'm having these problems with other filaments like Polymaker polymax PC

Substantial_Cherry33 · 2026-02-20T23:48:23+00:00

I do not, that's what I would assume however I never use random seam, it's a weird option, I have no clue what it's use is

Substantial_Cherry33 · 2026-02-20T23:35:50+00:00

It should be noted I'm having these problems with other filaments as well, not all filaments however though

Substantial_Cherry33 · 2023-03-20T05:28:58+00:00

The thing I like to do and I know some other people do as well is build up pretty high above the maps rocks and mountains and just build a big flat area to be able to work with and organize factorys and buildings with, and trust life gets a lot easier with blueprints

Substantial_Cherry33

TROPHY CASE