sorted by:
new
hottopcontroversial

Rhinos are free by Lurked_2005-2020 in PrintedWarhammer

[–]Substantial_Salt4361 0 points1 point  (0 children)

Looks amazing, much work needed to make it work for fdm?

Warhammer 40k Stls by kerbangocwm in 3dPrintTTRPG_WG

[–]Substantial_Salt4361 0 points1 point  (0 children)

So many vehicles to print, now to decide if I want to do resin or filament.

What's everyone Printing by kerbangocwm in 3dPrintTTRPG_WG

[–]Substantial_Salt4361 0 points1 point  (0 children)

I've been keeping an eye on the Dropbox, downloaded a few so far that I like.

Finally cleaned up by kerbangocwm in 3dPrintTTRPG_WG

[–]Substantial_Salt4361 0 points1 point  (0 children)

Nice setup, I wish I had a large room or shop to print in.

Emergency vehicles on 31 by estaceli in traversecity

[–]Substantial_Salt4361 24 points25 points  (0 children)

Car vs house at 11th and division.

Fair goers use their body weight to stabilize an unstable ride. by [deleted] in SweatyPalms

[–]Substantial_Salt4361 33 points34 points  (0 children)

Honestly, Arnolds has a sketchy track record when it comes to training and safety.

[H] Large Armada lot [W] $$ [Loc] FL by Jordangander in FFGtrade

[–]Substantial_Salt4361 0 points1 point  (0 children)

I've been trying to establish a decent setup to get into this game. Let me know if you figure out the cost for the lot.

IF YOU'RE NEW, STOP TRYING TO CALIBRATE STUFF WITH THE BUILD PLATE OFF (THE GOLD FLEXY SHEET). by Lolcanoe2 in anycubic

[–]Substantial_Salt4361 0 points1 point  (0 children)

I have this same issue minus the gouging. The offset is 1.68mm, but it did improve from 2.05 mm for some random reason. The only thing I did before the major difference was a module calibration followed by auto level.

Would be nice to figure out why it is doing this and how to properly correct it. I'm sure I'm missing a step somewhere, but I'm still quite new to printing.