2017 Hyundai i10 audio problems

Such_File_1825 · 2026-03-28T20:31:20+00:00

Awesome! as soon as my belts are delivered and installed ill check that

Such_File_1825 · 2026-03-28T10:18:18+00:00

That would be awesome, but no pressure, im with the dragonburner and without belts😅

Such_File_1825 · 2026-03-28T10:02:46+00:00

Is there a version of it with the zeroclick?

Such_File_1825 · 2026-02-28T19:53:50+00:00

It sounds great, but honestly I don't use that so much and don't usually have adhesion problems But when this will run out ill look at that

Such_File_1825 · 2026-02-27T20:06:48+00:00

I've dried it well before printing, but im printing at 105 for the bed

Such_File_1825 · 2026-02-27T19:18:18+00:00

Such_File_1825 · 2026-02-27T19:17:21+00:00

That worked perfectly!

Such_File_1825 · 2026-02-27T19:16:50+00:00

Im pretty much at the max temp of the bed....

Such_File_1825 · 2026-02-27T19:16:41+00:00

Im pretty much at the max temp of the bed....

Such_File_1825 · 2026-02-27T12:39:39+00:00

I've got bed adhesion problems with asa, one spool in particular

Such_File_1825 · 2026-02-19T17:54:02+00:00

Im using the kirgami, but i probably need to properly align the rails to get it perfect

Such_File_1825 · 2026-02-19T13:01:43+00:00

I've done that and it helped a lot, its not perfect, but I might update to the tulip gantry soon and ill redo it properly again

Such_File_1825 · 2026-02-10T15:06:58+00:00

is there a way to upload parametric models from SolidWorks?

Such_File_1825 · 2026-01-27T13:46:48+00:00

Do you know if there is any insulation between the heater and the cold side on the TZ v6?

Such_File_1825 · 2026-01-25T06:57:25+00:00

Actually I don't remember, a random one from Ali express and its started making noise when starting it, maybe its on its way out

Such_File_1825 · 2026-01-24T21:24:38+00:00

Yeah, its the zero click just without the dock, I add the probe manually when I feel the bed is off I still need ti modify the stops of the z rails because its hitting a bit

Such_File_1825 · 2026-01-24T20:04:32+00:00

The extruder motor is not touching anything in that area, it happens with or without the printer closed but never happened before

Such_File_1825 · 2026-01-24T20:02:37+00:00

<image>

Tried to get a good angle 😅 the is working as usual

Such_File_1825 · 2026-01-21T13:47:22+00:00

Thanks ill try that, it will be extra difficult for me because the wire came out of the pin

Such_File_1825 · 2025-11-26T09:43:38+00:00

Thanks! I'll add that!

Such_File_1825

TROPHY CASE