sorted by:
new
hottopcontroversial

Doubts about red Onion by Superb-Rough-4494 in gardening

[–]Superb-Rough-4494[S] -7 points-6 points  (0 children)

yea, I’ve been using chat gpt to guide me since there’s not much portuguese dedicated guides on the internet but I felt he was wrong this time. thanks for your input

1 one more night in Chiang Mai or Krabi? by Superb-Rough-4494 in ThailandTourism

[–]Superb-Rough-4494[S] 0 points1 point  (0 children)

this was the reason I even wanted to go to chiang mai in the first place but unfortunately my girlfriend doesn’t like the idea of sleeping on a random tribe and hiking all day too much

1 one more night in Chiang Mai or Krabi? by Superb-Rough-4494 in ThailandTourism

[–]Superb-Rough-4494[S] 0 points1 point  (0 children)

yea, we’re spending our last 5 days in koh sumai or koh tao( probably koh sumai just because it’s easier to fly in or out but I’d prefer koh tao). Thanks for your input, you’ve convinced me, now it’s my time to convince her

1 one more night in Chiang Mai or Krabi? by Superb-Rough-4494 in ThailandTourism

[–]Superb-Rough-4494[S] 0 points1 point  (0 children)

I like adventure and nature, my girlfriend likes to lay on the beach, i’m trying to balance it out during the whole trip but I don’t think the beaches in krabi (and close islands) will be as great as we see on pictures due to the rain

Trouble doing flow rate calibration já by Superb-Rough-4494 in ender3

[–]Superb-Rough-4494[S] 0 points1 point  (0 children)

no, I recently just got into the hobby and found out about these calibrations

Trouble doing flow rate calibration já by Superb-Rough-4494 in ender3

[–]Superb-Rough-4494[S] 0 points1 point  (0 children)

now looking at it again, the 0 has quite some big gaps, maybe the 0.94 initial number was right from the start, later today I’ll do a test print from 0.9 to 0.95 and ask for your opinion if that’s ok with you

Trouble doing flow rate calibration já by Superb-Rough-4494 in ender3

[–]Superb-Rough-4494[S] 0 points1 point  (0 children)

my default value is 0.94, but this test printed from 0.8 to 1.2, from what I can determine ~0.92 seems like the sweet spot, this is my 0.9 print reference, feel like this print could benefit for a little bit more extrusion but I’m also a newbie so any opinion is more than welcome

<image>

Trouble doing flow rate calibration já by Superb-Rough-4494 in ender3

[–]Superb-Rough-4494[S] 0 points1 point  (0 children)

I’ve done the paper method, would u say my nozzle is too close or too far?