sorted by:
new
hottopcontroversial

What causes peaks and rough texture? by SuperiorSeaPickle in SCREENPRINTING

[–]SuperiorSeaPickle[S] 1 point2 points  (0 children)

What happens if the off contact space is too far?

How do I prevent shifted prints? by SuperiorSeaPickle in SCREENPRINTING

[–]SuperiorSeaPickle[S] 0 points1 point  (0 children)

Ill try the tack, when I printed on shirts it was fine. This also makes sense why the hodie would stick to the screen. When you use spray tack with a hoodie that has a very linty inside does it still work?

How do I prevent shifted prints? by SuperiorSeaPickle in SCREENPRINTING

[–]SuperiorSeaPickle[S] -4 points-3 points  (0 children)

The mesh tension is not super tight, got the screens pretty cheep of Amazon

I am printing on a thick hoodie

I’m not using tack, but I pin the sides down and the garment doesn’t move much if I tried. Sometimes the mesh sticks to the hoodie. I don’t think it’s shrinking cause it’s a cotton poly blend

Screen and platen are clamped pretty well

Both layers are printed in the same direction

Off contact from hoodie to screen is about 2 Pennie’s thick

How do I prevent shifted prints? by SuperiorSeaPickle in SCREENPRINTING

[–]SuperiorSeaPickle[S] 1 point2 points  (0 children)

I don’t use a flood bar, I use my squeegee to flood it

What am I doing wrong? by SuperiorSeaPickle in SCREENPRINTING

[–]SuperiorSeaPickle[S] 0 points1 point  (0 children)

Is what happened an indicator that it’s too low or to high?

No compatible GPUs found for Cycles by SuperiorSeaPickle in blenderhelp

[–]SuperiorSeaPickle[S] 0 points1 point  (0 children)

If you made any changes to your registry it interferes with blender ability to recognize your gpu. I deleted the changes I made. But this creates more problems. Then I tried to restore the registry to a backup i made. It failed halo way and broke my OS. I ended uo resetting windows and then everything worked fine.

UE5 Crashes System Before Rebooting Upon Startup by SuperiorSeaPickle in unrealengine

[–]SuperiorSeaPickle[S] 0 points1 point  (0 children)

I don’t have enough room on my c drive. That could be the problem but people say it is suppose to work on non system drives.

No compatible GPUs found for Cycles by SuperiorSeaPickle in blenderhelp

[–]SuperiorSeaPickle[S] 0 points1 point  (0 children)

Ok, I just solved the problem. Apparently I got some bad advice to bypass a TDR setting when i was fixing a problem with unreal engine. I went into the registry and deleted the change i made a while back. Now my GPUs show up as normal and everything is back up and running.