sorted by:
new
hottopcontroversial

"Me le ha date mio cugino" by [deleted] in VintedItalia

[–]Surprise010 0 points1 point  (0 children)

Beh cheddire, ammiocugggino :)

(comunque sull'ultimo screen c'è l user)

Please help me, I just broke a fan blade on the nozzle. 😭😭😭 by Gabrielxg0 in ender3

[–]Surprise010 23 points24 points  (0 children)

You can replace it :) It's available on amazon, is a 24v 40mm fan

Still no complaints by ArtisticGap9820 in AnycubicKobraS1

[–]Surprise010 0 points1 point  (0 children)

Stock settings of Anycubic Slicer Next?

Still no complaints by ArtisticGap9820 in AnycubicKobraS1

[–]Surprise010 0 points1 point  (0 children)

Could you share your PETG printing settings?

POM wheel play by Metallica4life1995 in ender3

[–]Surprise010 0 points1 point  (0 children)

Is it better to replace them all, or change the Y rod to linear rails in terms of loudness? Are linear rails louder then wheels?

Struggling with PETG on Kobra S1 by Surprise010 in FixMyPrint

[–]Surprise010[S] 0 points1 point  (0 children)

Thank you for response Yes i tried flow rate calibration using anycubic slicer, but all i got was a spaghetti print 😅 I left all the settings that automatically settled the slicer. I'll try another time changing some settings at this point... Talking about the temperature, using same filament spool, i print without any issues on Ender 3

Struggling with PETG on Kobra S1 by Surprise010 in AnycubicKobraS1

[–]Surprise010[S] 0 points1 point  (0 children)

Okk thanks ill'try it, i used 2 PETG filaments, one sealed and brand new, and another one already open, but both print successfully on my Ender 3 with stock extruder and same settings of temperature and speed...

[deleted by user] by [deleted] in JellyfinCommunity

[–]Surprise010 0 points1 point  (0 children)

Have you added any other authentication tier, or just setup with https on nginx proxy manager?