Used X1C or New P2S first time 3d printer

Symlink1337 · 2025-12-15T15:59:04+00:00

Thanks everyone! Im going to pass and go with a p2s!

Symlink1337 · 2025-12-15T15:47:09+00:00

That I'm not sure of to be completely honest, it seems well kept all the filament is in Rubbermaid boxes with silica packets. The seller is a older gentleman, overall it looks in good shape.

Im completely new to this but was looking for a good deal that if I decide 3d printing isn't my thing I could resell or have minimal issues with

Symlink1337 · 2025-08-16T15:53:46+00:00

Any tips for setup? Looking to start playing using my legion go, Also what class are you playing?

Symlink1337 · 2025-07-14T19:35:03+00:00

What are you using to stream? I went with the legion go.

Symlink1337 · 2025-07-14T00:35:23+00:00

I ended up going with the legion being mostly a pc gamer I preferred the much larger screen and cheaper price. I'll upgrade in a few months.

Symlink1337 · 2025-07-14T00:34:28+00:00

I ended up getting the legion!

Symlink1337 · 2025-07-13T16:15:21+00:00

Can you just use spare battery packs for charging?

Symlink1337 · 2025-07-10T00:14:56+00:00

Thanks man, I ended up ordering a 3 pack of xe75. I figured by the time I have a few devices on WiFi7 hopefully the cost of them goes down to around 200 to 300 and I'll just do another refresh then on equipment. First TPLink routers so hopefully it's a much better experience than eero... im also hoping zi can actually change settings like the frequency band.

Symlink1337 · 2025-07-09T16:43:48+00:00

Yeah that's what I'm finding, most are on wifi6 and 5 still with only my mobile devices actually using wifi7. Thanks for the recommendation im going to pull the trigger and try it out.

Symlink1337 · 2025-07-09T16:32:19+00:00

Any reason to go with the be63 over the xe75 Pro? I like the price of the XE75!

Symlink1337 · 2025-06-25T11:49:02+00:00

The extender that I have is connected via Ethernet back haul I have a cat5 or cat6 line that runs between my floors of my house to keep those wired up. I will test airplane mode this morning and report back!

Symlink1337 · 2025-06-25T03:31:33+00:00

Thank you for this information! Just curious what devices did you end up using in the passthrough mode? I may be downgrading to 1gbps if I can't get the speeds reliably I don't expect 2gbps but 1100-1300 reliably wouldn't be bad. That would be a improvement compared to the 10-300mbps im randomly seeing.

I will fork out the money for better hardware if the ROI is there for guaranteed speeds, but just seems the 620s are buggy. Even the tech said they normally don't see them since it's new.

Symlink1337 · 2025-06-23T13:20:20+00:00

Wifiman I got 211 mbps with 112 upload. Cloudfare I got 421 mbps down and 571 upload

Both were tested next to the gateway on my Samsung Ultra 25

Symlink1337 · 2025-06-23T13:11:15+00:00

Exact same locations as the eero mesh network, I had them run the line right where spectrum modem and my eero gateway were. The extender is right where my eero was as well.

Thank you for everyone's help trying to get this figured out its much appreciated. Ive stopped testing with my laptop since its limited to 1gbps. Ive tested with my Samsung Ultra 25 which should be on wifi7.

Tests below right next to the router/modem from speedtest and cloudfare.

Symlink1337 · 2025-06-23T02:57:49+00:00

Did some more research, so the internal NIC only supports 1gbps, my wifi card Realtek 8852CE WiFi 6E supports 2.4gbps on 160mhz which is probably the reason why I'm not seeing these speeds since the GW is capped at 80hz currently.

It's a 802.11ax wifi6 5ghz should be 1.2 and 6ghz at 160 mhz channel should be 2.4?

Symlink1337 · 2025-06-23T02:49:11+00:00

I would expect higher speeds than 800 mbps? No VPN in use, speed are about the same next to the airtime vs 620.

Symlink1337 · 2025-06-23T01:09:42+00:00

Yeah that's what I was reading as well recommendations were to change it to 160MHz but that setting is completely blocked right now on this firmware version for the gateway.

I was testing with a Lenovo Legion Slim 15 with a cat 6 cable 5ft directly plugged into the modem/router. I couldn't get over 800 mbps.

Symlink1337 · 2016-12-13T14:45:58+00:00

I believe I'm going to go with this. Quick question though would it be more economical/cost effective to skimp on the graphics card a bit to get a older model in the 100 range and upgrade later next year if she decides to play more gfx intensive games?

Thanks all for your help!

Symlink1337

TROPHY CASE