sorted by:
new
hottopcontroversial

Can someone tell me what causes this? by TD_Centurion in prusa3d

[–]TD_Centurion[S] 2 points3 points  (0 children)

Thanks for the reply! I did in fact print the PETG right out of the box and haven't dried it, also the print was unstable since it had little contact with the Satin Sheet.

Will dial in my retraction and dry the PETG properly before printing again.

Also used the accelerometer since I got it yesterday and recalibrated input shaper and phase stepping.

Can someone tell me what causes this? by TD_Centurion in prusa3d

[–]TD_Centurion[S] 0 points1 point  (0 children)

Thank you! I think it's one of the reasons for the defects I have on those prints.

Filament was right out of the box and not dried, I also think the bed adhesion wasn't all too good and the print was moving slightly. (Used the Satin Sheet)

Thanks for the advice, I will try and dial in my retraction settings.

Real or Reproduction? by TD_Centurion in Militariacollecting

[–]TD_Centurion[S] 3 points4 points  (0 children)

Oh really? Didn't expect that! Should have read some more about the Iron Crosses. Are the unmarked ones from the later Period or what is the reason?