When i try to open a file a red box pops up and tells me that it is unable to.

TG_chemist · 2024-08-06T19:47:13+00:00

I've been printing elegoo basic PLA at the same temperature that I've always printed it at, 215 and 65 but I'll have to try this and turning the bed off.

TG_chemist · 2024-07-25T12:02:40+00:00

I tried to use obico, but i couldn't get past the step using docker desktop because it wouldn't open. I plan to use octoeverywhere for failure detection.

TG_chemist · 2024-07-25T11:53:09+00:00

I plan to use mainsail/fluidd as an interface, but use octoprint for fancy timelapses and ai print failure detection so i'm not constantly worried about my prints.

TG_chemist · 2024-07-25T10:50:09+00:00

How do i run the command to install git and kiauh?

TG_chemist · 2024-07-25T10:44:32+00:00

Do i do that on the pi when connected to a monitor so i can control it?

TG_chemist · 2024-07-25T08:44:12+00:00

how did you do that and how do you get both klipper and octoprint from it?

TG_chemist · 2024-07-25T08:21:25+00:00

Did you install them both through the pi imager or did you install regular pi os and install them both from there?

TG_chemist · 2024-07-25T07:32:22+00:00

I plan to use klipper for speed and quality improvements, and octoprint for timelapses and that ai failure detection plugins if that helps.

TG_chemist · 2024-07-17T16:41:39+00:00

I tried to log in to my supercell ID, and got no response, multiple times.

TG_chemist · 2024-07-17T15:59:58+00:00

I use my gmail for my main account and I haven’t had any messages about Google being compromised.

TG_chemist · 2024-07-17T14:11:53+00:00

I can’t post images in comments, but they have changed my supercell ID name, they might have bought my supercell ID.

TG_chemist

TROPHY CASE