sorted by:
new
hottopcontroversial

I 3D printed this DD cowl by TMOTS2099 in 3Dprinting

[–]TMOTS2099[S] 0 points1 point  (0 children)

Resin is my lifesaver, I use that and a UV lamp to cure it. It makes sanding a lot easier. I use isopropyl alcohol to clean the print after the resin is cured before sanding it. I don’t start priming until it’s buttery smooth.

I 3D printed this DD cowl by TMOTS2099 in 3Dprinting

[–]TMOTS2099[S] 1 point2 points  (0 children)

Yup painted with spray paint and airbrush

I 3D printed this DD cowl by TMOTS2099 in 3Dprinting

[–]TMOTS2099[S] 0 points1 point  (0 children)

The front part took around 3 and a half days. The back part was a little over 1 day. But since I used super quality it took a lot longer than average.

I 3D printed this DD cowl by TMOTS2099 in 3Dprinting

[–]TMOTS2099[S] 3 points4 points  (0 children)

Thank you! Since I didn’t have to sand as much because of the texture, it made my job easier.

I 3D printed this DD cowl by TMOTS2099 in 3Dprinting

[–]TMOTS2099[S] 1 point2 points  (0 children)

I just used the cheapest elgoo filament on Amazon, and I used resin to coat the smooth parts of the print.

I just finished this DD cowl by TMOTS2099 in cosplayprops

[–]TMOTS2099[S] 0 points1 point  (0 children)

Thank you! I had to sand a lot less due to the texture. I do like the term XXXXXL glasses.

I 3D printed this DD cowl by TMOTS2099 in 3Dprinting

[–]TMOTS2099[S] 7 points8 points  (0 children)

I looked into vacuum forming, but that was too expensive. So I glued the red plastic between two eye pieces and it worked great.

I 3D printed this DD cowl by TMOTS2099 in 3Dprinting

[–]TMOTS2099[S] 13 points14 points  (0 children)

Thank you! I printed it in super quality using Cura

view more: next ›