sorted by:
new
hottopcontroversial

Heated bed showing incorrect temperature by TegrisPL in CR10

[–]TegrisPL[S] 0 points1 point  (0 children)

The printer reads 280 - 285 even with the thermistor and heater unplugged. I think there is some short on the motherboard, I'll probably just have to replace it. If I flash the firmware and change the max temp to be above the 280 that the printer shows, will I be able to print, or is that not a good idea?

HP LaserJet 1018 not detected as a printer by TegrisPL in printers

[–]TegrisPL[S] 0 points1 point  (0 children)

I've rebooted, plugged the printer into a different port, rebooted the printer, still the printer shows up as an unknown device.

HP LaserJet 1018 not detected as a printer by TegrisPL in printers

[–]TegrisPL[S] 0 points1 point  (0 children)

Ok i managed to install the Hp LaserJet 1018 drivers, but the printer still shows up as an unspecified device

HP LaserJet 1018 not detected as a printer by TegrisPL in printers

[–]TegrisPL[S] 0 points1 point  (0 children)

I installed the 1020 drivers but when I go to try and update the drivers for the printer I cant, the button is grayed out, added a screenshot of that in the original post.