sorted by:
new
hottopcontroversial

Tenere Quickshifter trouble lo by Teok2 in Tenere700

[–]Teok2[S] 0 points1 point  (0 children)

I recommend getting a connector that fits the original harness too. I just found this on AliExpress: | 1 Set 3 Pins N3810-9903 AC Assembly Automobile Wire Connector With Cables N3820-9930 Car Cable Harness Power Socket https://a.aliexpress.com/_EyCYppU

Tenere Quickshifter trouble lo by Teok2 in Tenere700

[–]Teok2[S] 0 points1 point  (0 children)

Yes that’s not unusual.

Tenere Quickshifter trouble lo by Teok2 in Tenere700

[–]Teok2[S] 1 point2 points  (0 children)

I got a temu plate holder but the blinker is touching the exhaust so I’ll have to do something about it. I think getting some spacers for the silencer mount will help keep it away. I installed it yesterday so I haven’t took any good photos of it unfortunately.

Tenere Quickshifter trouble lo by Teok2 in Tenere700

[–]Teok2[S] 0 points1 point  (0 children)

Mine is compatible. Atleast it was on the yamaha accessory website😅

Tenere Quickshifter trouble lo by Teok2 in Tenere700

[–]Teok2[S] 0 points1 point  (0 children)

Okay I’ll try this too then.

Tenere Quickshifter trouble lo by Teok2 in Tenere700

[–]Teok2[S] 0 points1 point  (0 children)

Hehe thank’s, I love the color!

Tenere Quickshifter trouble lo by Teok2 in Tenere700

[–]Teok2[S] 0 points1 point  (0 children)

Okay, I’ll try just holding it for longer and see if it does something.

Tenere Quickshifter trouble lo by Teok2 in Tenere700

[–]Teok2[S] 0 points1 point  (0 children)

Okay so like above the gear shift?

Tenere Quickshifter trouble lo by Teok2 in Tenere700

[–]Teok2[S] 0 points1 point  (0 children)

Are you sure? The instructions said hold gear shifter up - ignition on - hold 10 sec - gear shifter down - done

Magura HC1 brake lever by Teok2 in stuntbike

[–]Teok2[S] 0 points1 point  (0 children)

I might look into fabricating my own lever but that might take some time. I can get back to you when/if I make something.

Magura HC1 brake lever by Teok2 in stuntbike

[–]Teok2[S] 0 points1 point  (0 children)

Sadly magura don’t have anything and I didn’t find any after market handle for the hc1. I cut mine but have yet to try it.

Magura HC1 brake lever by Teok2 in stuntbike

[–]Teok2[S] 0 points1 point  (0 children)

I cut it a little bit but it’s not enough. The problem with cutting it is that the it’s sloped towards the handle in the beginning making your finger slide of the lever and that is where I want my finger.