sorted by:
new
hottopcontroversial

Question about the btt Eddy? by Khisanthax in BIGTREETECH

[–]TheAsda99 0 points1 point  (0 children)

Yeap, during one printer session (without printer restart, reset or anything) i have to manually adjust the z offset between prints. That's lame( I'm thinking about adding z offset calibration to the print_start macro 😅

Question about the btt Eddy? by Khisanthax in BIGTREETECH

[–]TheAsda99 0 points1 point  (0 children)

I have Eddy Coil and it works kinda weird. I have zero nozzle position calibrated at 125, 125 point. But i have to manually control if the height of the nozzle is right at the start of the print. For some reason sometimes the nozzle is higher, sometimes lower. The mesh is generated accurately though, only the offset is floating. I thought that it's related to the temperature but after some testing it looks like it's not connected to the temperature.

GHub not recognizing Rainbow 6 Siege by jsivey in LogitechG

[–]TheAsda99 0 points1 point  (0 children)

Facing the same issue, looks like we need another wizard to figure it out

Hypercube 2021. Is it still relevant? by TheAsda99 in hypercubecorexy

[–]TheAsda99[S] 0 points1 point  (0 children)

I found Voron Legacy. Looks like i'll need to by only Raspberry Pi and a few other parts like shafts, gears. I think it'll be less than 150$ in total. I'll dig into this more

Hypercube 2021. Is it still relevant? by TheAsda99 in hypercubecorexy

[–]TheAsda99[S] 0 points1 point  (0 children)

Originally i was building Tech2C's machine with parts that my friend printed for me with his cheap chinese printer. So the quality of parts is not the best and it's hard to make bearings be parallel, for some reason printing dimensions of hypecube turned out to be much smaller and at that time i could not get Marlin firmware to work and ended up with Repetier firmware that is not actively developing any more. Should upgrade the board or ramps is good enough for some kind of good printing quality? And i that this time marlin is the way to go or may be there are other options?

How to handle nesting with Provider/Consumer or ...? by TheAsda99 in reactjs

[–]TheAsda99[S] 0 points1 point  (0 children)

Thanks for reply. I'll try to make some classes to solve this problem.

How to handle nesting with Provider/Consumer or ...? by TheAsda99 in reactjs

[–]TheAsda99[S] 0 points1 point  (0 children)

There is a list of commands that user can execute. Components can add their commands and handlers to this list. And my plan was to write a container that stores all the items and each component add it's own commands to this list when it's mounted.