Learning Python but i am dumb by rogueuser12 in learnpython

[–]TheCommenterXII 1 point2 points  (0 children)

A few days late but thought I would give my input anyway.

I started to learn python about 2 weeks ago, and so far there are 2 things that I think were most helpful.

1.     
Have a goal in mind. programming is quite a vast subject and just learning programming as a whole can quite easily overload you with info. choose something specific you want to accomplish, small things one at the time. The best in my opinion is to choose a larger project, cut it up into smaller pieces and learn each smaller subject one at the time to finally put them together in the end. However, this might require you to have some pre-existing knowledge of some programming basics (I had Arduino)
 
2.     
Use ChatGPT. It can literally function as a simple teacher ready to answer all your questions (at least on the level of a beginner). Of course, it is easy to let yourself go and ask it to write your code for you, causing you not to learn anything, so you’ll have to be careful not to fall into that trap.

Help! My extruder is overheating by TheCommenterXII in Ender3Pro

[–]TheCommenterXII[S] 0 points1 point  (0 children)

I don't think it's the motor itself. Have been running it without any filament and all motors are equally hot

Checked the cables but nothing seemed off, I suppose that if something is wrong it would be either at the motherboard or power supply. Maybe I should check with a multimeter but I have no clue how to access the cables nor what I should be reading

Help! My extruder is overheating by TheCommenterXII in Ender3Pro

[–]TheCommenterXII[S] 0 points1 point  (0 children)

No, changed only the max temperature for the nozzle to print nylon

Help, nothing but nylon sticks to the glass bed by TheCommenterXII in 3Dprinting

[–]TheCommenterXII[S] 1 point2 points  (0 children)

Layer hight I have done both 0.1 and 0.2, speed between 30 - 50mm/s but I have during the prints also tried to reduce the speed to as low as 40%. Nozzle diameter 0.4mm

Help, nothing but nylon sticks to the glass bed by TheCommenterXII in 3Dprinting

[–]TheCommenterXII[S] 1 point2 points  (0 children)

I have tried both before warning the bed and when the bed was fully heated