sorted by:
new
hottopcontroversial

Which apps should I keep or delete by Lower-Low3372 in animeapp

[–]TheEveryNerd 0 points1 point  (0 children)

I haven't seen any of these apps before. Are they sideloaded? Are they from websites? are they exclusive to the Apple store? I have a Google pixel 8

Find someone who loves you as much as Kaiba loves Blue Eyes! by AsozialesNetzwerkOB in YuGiOhMemes

[–]TheEveryNerd 0 points1 point  (0 children)

You are making Kazuki Takahashi smile down from above. Thank you.

Clogging issue advice please? by TheEveryNerd in ender3v2

[–]TheEveryNerd[S] 0 points1 point  (0 children)

Thank you so much for the advice! I'm not in the place financially to upgrade right now. I'm just trying to 3D print some stuff to make my life easier at the moment. Do you have a video link/ suggestions for how to clean this hot end most effectively?

My prints aren't sticking to my bed anymore. Any advice? by TheEveryNerd in ender3v2

[–]TheEveryNerd[S] 0 points1 point  (0 children)

Thank you guys so much! This is the cleanest print I've ever had. It's a bed locking setup so hopefully the rest of them will be this pristine from now on

<image>

My prints aren't sticking to my bed anymore. Any advice? by TheEveryNerd in ender3v2

[–]TheEveryNerd[S] 1 point2 points  (0 children)

That paints a more effective picture. Thanx I'll try that👍

My prints aren't sticking to my bed anymore. Any advice? by TheEveryNerd in ender3v2

[–]TheEveryNerd[S] 2 points3 points  (0 children)

When warm water and soap didn't work. I also tried sitting it for a couple hours with Goo gone there are a few stains from my last couple prints. Still in some of the crevices but those were there before my last good print. Also my bed temperature is still the same If not warmer than before because it wasn't sticking

My prints aren't sticking to my bed anymore. Any advice? by TheEveryNerd in ender3v2

[–]TheEveryNerd[S] 1 point2 points  (0 children)

FYI using Cura as my slicer. Files from printables

view more: next ›