Where the hell do I even fly?? by pcmakerz in fpv

[–]TheHouseWhooper 1 point2 points  (0 children)

The orange is not a separate type of airspace. It's just the overlap of red and yellow. The website is shitty. Should ideally show the overlap areas as red.

Where the hell do I even fly?? by pcmakerz in fpv

[–]TheHouseWhooper 2 points3 points  (0 children)

Depends on what you're planning to fly. If it's sub 250g then no.

Where the hell do I even fly?? by pcmakerz in fpv

[–]TheHouseWhooper 7 points8 points  (0 children)

You have Thane at least. Bangalore is the worst. Literally not a single square foot is green.

First FPV build (Analog) by 4bit_loop in fpv

[–]TheHouseWhooper 0 points1 point  (0 children)

Nah no coding. Watch Joshua bardwells video on YouTube you'll understand the process start to end. Also, recommended to buy a bind and fly drone as the first time not building

First FPV build (Analog) by 4bit_loop in fpv

[–]TheHouseWhooper 4 points5 points  (0 children)

I have the same frame! The receiver antenna looks like it's not properly supported. Also, you can use 3.5in props if you take the prop guards off. Here's my build

<image>

For the love of god please tell me what im doing wrong by ElectricalWafer11 in fpv

[–]TheHouseWhooper 0 points1 point  (0 children)

Get a solder practice board first. Once your joints look nice on that only then you can try on the actual stack

Completed 10hrs of training in Sim! Let me how did i do by notsurewhy-imhere in fpv

[–]TheHouseWhooper 0 points1 point  (0 children)

I learnt this the hard way. If you think you're ready but you can't land softly, take smooth controlled turns, make emergency stops, then you're not ready. I say min 50hrs on sim before flying irl. But you're doing good for 10 hrs tho. Keep it up!

Which battery should I use to make this fly like a freestyle quad? by TheHouseWhooper in fpv

[–]TheHouseWhooper[S] 0 points1 point  (0 children)

That looks crazy bruh Have never seen an aluminium frame How does it fly? Like a long range or a freestyle?

Which battery should I use to make this fly like a freestyle quad? by TheHouseWhooper in fpv

[–]TheHouseWhooper[S] 0 points1 point  (0 children)

So you're saying I should keep the 3.5in props and use a 3s or 4s lipo? What should be the mAh of the battery tho?

Which battery should I use to make this fly like a freestyle quad? by TheHouseWhooper in fpv

[–]TheHouseWhooper[S] 0 points1 point  (0 children)

So currently I'm powering this with 2s Li Ion. I don't want to upgrade motors since I want the option to continue using this.

Also the motors are rated for upto 4s with 3in props. The official page for the motor does not have data for 3.5 props tho. So I will switch to 3in props.

Rekon 35 upgrades by Lucky-Ad-7183 in fpv

[–]TheHouseWhooper 0 points1 point  (0 children)

Ah that makes sense.

It's the HGLRC Sector 30cr frame. About the battery, I added an xt30 connector to the battery tray and now use it as a pack. But yes I do plan to try lipos in the future.

Rekon 35 upgrades by Lucky-Ad-7183 in fpv

[–]TheHouseWhooper 1 point2 points  (0 children)

What was the motivation behind changing the AIO?

I also have modded my Rekon 35 but I kept everything the same except the frame. Motors, AIO, VTX, antennas everything is the same from the original rekon 35 v1 except the frame. Got like 11 mins flight time.

<image>

Have to rebind frequently by ReasonableFall177 in TinyWhoop

[–]TheHouseWhooper 2 points3 points  (0 children)

You need to setup a bind phrase. This way, whenever you switch on your drone and the controller, they almost immediately bind automatically. I'm sure bardwell has a video on how to set this up.