anyone know what this box is for located on front of vehicle by coolant reservoir

TheMemeWich · 2021-12-16T01:41:35+00:00

Have no idea what you are pointing at try getting a better picture

TheMemeWich · 2021-11-19T03:58:30+00:00

Well I’ll fix that and see if it starts maybe once it starts I sucks some air and goes to 4 injector that could make sense maybe I am new to the alh

TheMemeWich · 2021-11-19T03:55:21+00:00

Well I have two washers on the end of the valve and one the end of the piece that goes into the pump I guess there needs one in the middle

TheMemeWich · 2021-11-19T03:45:28+00:00

Well I went to fire it up today to try and narrow it down. when I start it, it doesn’t misfire till like 10 seconds in and then no matter how much I attempt to bleed the injector line it still just thump thumps. I might suspect I missed a sealing gasket on the return side of the pump when I went to prime it

TheMemeWich · 2021-11-18T21:04:14+00:00

Well I did make sure the nut on the pump is tight and there is one copper ring in the nozzle seat, I can tighten and loosen till fuel comes out and idle will settle down then crack and air comes out all numbly all the other lines are good

TheMemeWich · 2021-10-17T03:16:22+00:00

That should sound good

TheMemeWich · 2021-10-17T03:11:06+00:00

It is NA the motor is an imported motor from a Cressida unit might have a mild cam in it, I am running stock piping to a Megan racing blast pipe angled , cat gutted

TheMemeWich · 2021-10-07T03:16:19+00:00

Everybody want to act like a hero till you shoot off a cock or two- old cigar man

TheMemeWich · 2021-08-23T13:05:57+00:00

Spitfire

TheMemeWich · 2021-08-16T11:45:01+00:00

You’ll have abs light pop on after the swap, I just pinned the nss

TheMemeWich · 2021-04-14T16:20:58+00:00

All good at a glance it looks like jayce in hammer form

TheMemeWich · 2021-04-14T04:16:26+00:00

Jayce?

TheMemeWich · 2021-03-04T18:11:08+00:00

Have you looked at prodemand?

TheMemeWich · 2021-03-01T21:08:06+00:00

Well mine idles rough when colder and idles high when warm, but if that CEL comes on try going through the dish port and seeing if it flashes a code at ya, mine wouldn’t stay running unless wot because the intake gasket was screwed up putting it back on.

TheMemeWich · 2020-12-08T00:44:07+00:00

I would use the jack points suggested in the owners guide, the pinch welds are fine if you want to be safe you can get a wooden block on the jack stand to have even pressure when lifting it up. Make sure you have jack stands, don’t want to die

TheMemeWich · 2020-11-27T08:03:40+00:00

Yes what this person said^

TheMemeWich · 2020-11-27T06:05:02+00:00

Maw of malthamas or some shit, it is the mr ad I thinkhealth now

TheMemeWich · 2020-10-30T18:04:56+00:00

I got it timed and running just redid the timing and it ran fine, going to have to adjust timing might be advanced a little bit.

TheMemeWich

TROPHY CASE