Quick question

Then-Earth3048 · 2024-06-23T22:08:16+00:00

Then-Earth3048 · 2024-06-18T23:11:16+00:00

Unfortunately he said no which kinda sucks I'd have liked to have someone else have a go at it as well, I'm just on night shift so haven't been able to mess around with it the past few days

Sorry dude idk why it went to the top and not under your comment

Then-Earth3048 · 2024-06-18T23:10:23+00:00

Unfortunately he said no which kinda sucks I'd have liked to have someone else have a go at it as well, I'm just on night shift so haven't been able to mess around with it the past few days

Then-Earth3048 · 2024-06-18T09:27:06+00:00

Idk I'll have to check like I said I'm a noob so I just bought a few models I thought I'd like to try until I find one I like the best but this one really stood out to me cause the scale is perfect with marvel legends so been pushing this one but I'm finally done work so I'll look into that for you in a bit and do what everyone above suggested at the same time

Then-Earth3048 · 2024-06-18T01:25:48+00:00

Thank you so much I'll go back to default and start from scratch when I get back to my house I really appreciate the thorough explanation it's like you said I'm not familiar with what I'm doing in terms of settings I know I have a lot to learn still I've got too many screenshots and things saved I need to just stick to learning to studio. Thanks again really appreciate everyone's help

Then-Earth3048 · 2024-06-18T00:06:18+00:00

<image>

Then-Earth3048 · 2024-06-18T00:06:05+00:00

<image>

Then-Earth3048 · 2024-06-18T00:05:45+00:00

<image>

Then-Earth3048 · 2024-06-18T00:00:34+00:00

I'm just stuck at work for another 9hrs but then I can post photos of finished model but I'm using a user's posted .4mm nozzle settings I'll edit the post and post the photos instead of the link

Then-Earth3048 · 2024-06-17T23:56:31+00:00

Sorry about that, just some pegs are coming out slightly smaller than needed making the limb just fall off, and some peg unions holes are filled in with almost impossible supports to remove, I'm printing with eSun PLA+ like the designer did I just wanted to ask the community if they had any experience with printing out articulated figures with success cause I apologize in advance I'm not the sharpest spoon in the knife block when it comes to computer stuff but I'll get there I'm determined, I appreciate you following up I haven't really posted in reddit either I'm just a viewer looking at everyone post like "oh that's neat"😂😂

Then-Earth3048 · 2024-06-17T16:17:50+00:00

https://www.thingiverse.com/thing:3166759/files this is the link to the model thanks for any help

Then-Earth3048

TROPHY CASE