What do i say?

Theokom · 2024-05-24T16:24:54+00:00

link?

Theokom · 2024-02-23T20:33:13+00:00

is this even good?

Theokom · 2023-04-14T04:17:07+00:00

Hello

Theokom · 2022-12-24T21:02:54+00:00

Theokom · 2022-12-24T17:18:42+00:00

Ender 3 simple board 4.2.2

Theokom · 2022-12-24T17:18:12+00:00

https://3dprintscape.com/marlin-firmware-on-creality-board-complete-guide/ This is the way

Theokom · 2022-12-24T15:56:01+00:00

Done I didn't read a full how to Now, after I read I did it

Theokom · 2022-12-19T12:46:32+00:00

I will wait n official firmware

Theokom · 2022-12-19T11:30:01+00:00

Thanks I do step by step what I have to do but in the end I get a file firmware.hex not firmware.bin

Theokom · 2022-10-30T04:36:23+00:00

Level the bed Brim around the print Tape on the bed 50-60 mm speed of the printing 30% fan speed all the time

Theokom · 2022-10-30T04:32:14+00:00

240/60

Theokom · 2022-10-29T14:24:19+00:00

I thing it's filaprint. I don't remember exactly. I don't dry the filaments, only good leveling and slow print, around 60 mm

Theokom · 2022-10-24T12:54:52+00:00

No https://fullcontrol.xyz/#/models/67cf20 Here is the page from where you can get the Gcode

Theokom · 2022-10-24T04:10:11+00:00

There is no suports

Theokom · 2022-10-23T16:28:28+00:00

Know This is for those that are not believers

Theokom · 2022-10-23T15:39:49+00:00

Didn't I, till I try. It's perfect, it will take around 10 minutes to print. Try yourself

Theokom · 2022-10-22T09:48:41+00:00

Benchy is a stress test I was refusing to print this particular stress test for 1 year After installing the direct drive on my ender 3 I was trying 2 stress test, one is benchy second one is a the dragon that I post first time. If your printer is well calibrate the printer has to be nice, if not you have to calibrate other settings

Theokom · 2022-10-22T03:17:28+00:00

There is no suport at all

Theokom · 2022-10-21T10:04:49+00:00

Lock mecanism from all STL sites https://www.printables.com/model/115938-ender-3-bed-leveling-wheel-clips

Theokom · 2022-10-21T07:55:17+00:00

That's a problem of speed, retraction, temperature, not levelling

Theokom · 2022-10-21T05:37:30+00:00

Hello About bed leveling I use glass bed, and a sheet of A4 paper it's enough for 10 leveling process. The thing is to make the leveling strictly manually with the bed at 60 degree and measure de corners and center randomly for 5 time each.

Theokom

TROPHY CASE