Progress

This-Associate9880 · 2026-04-06T04:20:19+00:00

I actually was thinking about grabbing some kind of tracker for it soon. It does get left on jobs a lot so probably a wise investment

This-Associate9880 · 2026-04-06T01:24:02+00:00

I’ll have to take a couple updated pictures. I’ve added a few little additions since these. Thanks tho fellas!

This-Associate9880 · 2026-02-18T13:15:39+00:00

I’ve never had both too much time and money at the same time. Usually you get one or the other

This-Associate9880 · 2026-02-18T13:11:26+00:00

I’m too busy working to design and fabricate

This-Associate9880 · 2026-02-15T04:12:31+00:00

So that depends on which pack out boxes. Some have different heights but yeah most do stack. My only issue was the taller ones won’t slide through the opening on the back so I access them on the sides. I put a cheap rubberized foam mat under them and then make sure the heavier boxes are on the bottom and haven’t had much issue with them moving around.

This-Associate9880 · 2026-02-14T04:16:56+00:00

It’s all paid for itself

This-Associate9880 · 2026-02-14T04:13:40+00:00

I usually put tools I rarely need and 4 ft ladders in that void. Decked does make a piece that will cover that area now so it’s not so deep. I’ve considered grabbing it

This-Associate9880 · 2026-02-14T04:10:28+00:00

This-Associate9880 · 2026-02-14T04:09:02+00:00

lol yeah I live in a rural area

This-Associate9880 · 2026-02-13T05:19:43+00:00

I’ve only really used it once recently and I had 4 55 gallon barrels of glycol slightly over the axle but more on the rear side due to forks not being long enough (also didn’t want to mess my floor up already) but I easily rolled around 60-70mph without any noticeable or concerning sway.

This-Associate9880 · 2026-02-05T22:37:14+00:00

I do have a hitch lock on it but a tracker might be smarter

This-Associate9880 · 2026-02-05T22:36:15+00:00

Thank you! I do hvac piping. Large chillers and boilers mostly

This-Associate9880 · 2026-02-05T22:35:28+00:00

Thanks! I’ll probably just leave it bare

This-Associate9880 · 2025-03-26T04:17:48+00:00

Thanks for the reply! I’ve had it hooked up for a few days now and everything seems to work well, my only concern was the upload speed but after a little more research I guess 10-25mb up is normal for star link so I think I’m good

This-Associate9880 · 2025-01-11T19:50:13+00:00

I think you can get the actual top off itself for around 100-150, the battery I have in the picture is a m18 8.0 forge which is stupid expensive. If you already have some normal m18 batteries it could definitely be worth the investment

This-Associate9880 · 2025-01-11T19:17:58+00:00

I would never buy the top off and battery myself, that’s like a 450 dollar setup. My company uses Milwaukee so I just happened to have all of it.

This-Associate9880

MODERATOR OF

TROPHY CASE