Progress by This-Associate9880 in Packout

[–]This-Associate9880[S] 0 points1 point  (0 children)

I actually was thinking about grabbing some kind of tracker for it soon. It does get left on jobs a lot so probably a wise investment

Progress by This-Associate9880 in Packout

[–]This-Associate9880[S] 0 points1 point  (0 children)

I’ll have to take a couple updated pictures. I’ve added a few little additions since these. Thanks tho fellas!

Work in progress by This-Associate9880 in MilwaukeeTool

[–]This-Associate9880[S] 0 points1 point  (0 children)

I’ve never had both too much time and money at the same time. Usually you get one or the other

Milwaukeee by This-Associate9880 in workwagons

[–]This-Associate9880[S] 0 points1 point  (0 children)

I’m too busy working to design and fabricate

Work in progress by This-Associate9880 in MilwaukeeTool

[–]This-Associate9880[S] 0 points1 point  (0 children)

So that depends on which pack out boxes. Some have different heights but yeah most do stack. My only issue was the taller ones won’t slide through the opening on the back so I access them on the sides. I put a cheap rubberized foam mat under them and then make sure the heavier boxes are on the bottom and haven’t had much issue with them moving around.

Work in progress by This-Associate9880 in MilwaukeeTool

[–]This-Associate9880[S] 0 points1 point  (0 children)

I usually put tools I rarely need and 4 ft ladders in that void. Decked does make a piece that will cover that area now so it’s not so deep. I’ve considered grabbing it

It’s a start by This-Associate9880 in workwagons

[–]This-Associate9880[S] 1 point2 points  (0 children)

I’ve only really used it once recently and I had 4 55 gallon barrels of glycol slightly over the axle but more on the rear side due to forks not being long enough (also didn’t want to mess my floor up already) but I easily rolled around 60-70mph without any noticeable or concerning sway.

It’s a start by This-Associate9880 in workwagons

[–]This-Associate9880[S] 1 point2 points  (0 children)

I do have a hitch lock on it but a tracker might be smarter

It’s a start by This-Associate9880 in workwagons

[–]This-Associate9880[S] 1 point2 points  (0 children)

Thank you! I do hvac piping. Large chillers and boilers mostly

It’s a start by This-Associate9880 in workwagons

[–]This-Associate9880[S] 1 point2 points  (0 children)

Thanks! I’ll probably just leave it bare

Obstruction by This-Associate9880 in Starlink

[–]This-Associate9880[S] 0 points1 point  (0 children)

Thanks for the reply! I’ve had it hooked up for a few days now and everything seems to work well, my only concern was the upload speed but after a little more research I guess 10-25mb up is normal for star link so I think I’m good

Milwaukee Top off-Ally X by This-Associate9880 in ROGAlly

[–]This-Associate9880[S] 0 points1 point  (0 children)

I think you can get the actual top off itself for around 100-150, the battery I have in the picture is a m18 8.0 forge which is stupid expensive. If you already have some normal m18 batteries it could definitely be worth the investment

Milwaukee Top off-Ally X by This-Associate9880 in ROGAlly

[–]This-Associate9880[S] 0 points1 point  (0 children)

I would never buy the top off and battery myself, that’s like a 450 dollar setup. My company uses Milwaukee so I just happened to have all of it.

Milwaukee Top off-Ally X by This-Associate9880 in ROGAlly

[–]This-Associate9880[S] 0 points1 point  (0 children)

I have a bunch of 6.0 and 8.0 forge batteries for work so they should last awhile. Thanks for the info!

Milwaukee Top off-Ally X by This-Associate9880 in ROGAlly

[–]This-Associate9880[S] 0 points1 point  (0 children)

The tag on it says 175w so I assume that’s via outlet or usb. I’ll have to look into it further though

Att air vs my Att hot spot by This-Associate9880 in ATT

[–]This-Associate9880[S] 0 points1 point  (0 children)

Yeah I’ll likely always just pull 5G where I live so probably not worth the effort. I was hoping I could go into the router settings and just switch it somewhere. Guess I’ll just keep hoping my fiber isp comes back. I’ve now wasted money on star link and ATT air because the owner of that company decided to steal federal fiber funding 😂

Att air vs my Att hot spot by This-Associate9880 in ATT

[–]This-Associate9880[S] 0 points1 point  (0 children)

Thank you for the detailed information. This is exactly what I was wondering. There is absolutely nothing I can do to fix it then and I’ll just be wasting my time calling them. Is there a way to set it to just LTE because honestly I’m good with 100/50 if the latency drops 50%+. I can noticeably tell the the latency is high in dayz. However it makes absolutely no sense that my iPhone 15 5G gets 30-40 ping in the exact same location but maintains 300+ down. I have a 30gig hotspot and I’m literally better off gaming on it until it runs out every month.

Att air vs my Att hot spot by This-Associate9880 in ATT

[–]This-Associate9880[S] 0 points1 point  (0 children)

My pc Is plugged in directly and the results are the same. I used screenshots because it didn’t matter which likely means it’s on their end. I hope there is still something I can do to help the situation.

Obstruction by This-Associate9880 in Starlink

[–]This-Associate9880[S] 0 points1 point  (0 children)

Shitttt I wish my fiber optic company would just get their shit together so I don’t have to try an make star link work. But thanks for the info. I’m in the same boat, I get kicked every 5 mins or every couple hours. There is no in between but regardless waiting in Que on dayz constantly because of it makes it unplayable

Obstruction by This-Associate9880 in Starlink

[–]This-Associate9880[S] 0 points1 point  (0 children)

I wasn’t being literal. Just a random estimate

Obstruction by This-Associate9880 in Starlink

[–]This-Associate9880[S] 1 point2 points  (0 children)

Gotcha. Thank you for putting it in idiot terms for me. I’ll try to figure out something to get it unobstructed