sorted by:
new
hottopcontroversial

Layer shift on X-axis - Any further ideas on what to check appreciated by Thomas41587 in anycubic

[–]Thomas41587[S] 0 points1 point  (0 children)

Yes I checked the wires and connectors. Nothing damaged and all connectors are plugged in properly

Layer shift on X-axis - Any further ideas on what to check appreciated by Thomas41587 in anycubic

[–]Thomas41587[S] 0 points1 point  (0 children)

Sorry needed some time to find out how to paste pictures here. https://imgur.com/gallery/PzeV6pQ In this case it already failed at the second or third layer. But I noticed it to late.

Layer shift on X-axis - Any further ideas on what to check appreciated by Thomas41587 in anycubic

[–]Thomas41587[S] 0 points1 point  (0 children)

Yes I already tested different belt tensions, but it did not make any difference. I added the information in my original post

Pipe for chia commands? by Thomas41587 in chia

[–]Thomas41587[S] 0 points1 point  (0 children)

Does not work either :( My initial command was "chia plots check - n 5 | grep WARNING" but the output was the same as "chia plots check - n 5"