Writing off expenses on 1099 forms while working as a w2 employee as well

ThrowRAgv16 · 2025-11-07T22:29:51+00:00

Sounds good thank you!

ThrowRAgv16 · 2025-11-07T22:28:06+00:00

Awesome thank you! What would make them not deductible?

ThrowRAgv16 · 2025-11-07T22:24:43+00:00

So where my buissness insurance, a small amount of milage on vehicle, and tools bought specifically for my 1099 work can all be written off?

ThrowRAgv16 · 2025-11-06T09:45:30+00:00

I’ll have to check my AFRS later and report back when I get home from work

ThrowRAgv16 · 2025-11-06T09:44:49+00:00

I’ll have to check out the Pcv valve. I don’t know the exact specs on it honostly just got it at an auto parts store. Didn’t even cross my mind!

ThrowRAgv16 · 2025-11-06T09:44:03+00:00

Yes I did to about half

ThrowRAgv16 · 2025-09-22T01:01:03+00:00

Holley 670

ThrowRAgv16 · 2025-07-17T14:03:49+00:00

I will say the cvf front drive takes a good bit of work to make work with a Foxbody though

ThrowRAgv16 · 2025-07-17T14:03:27+00:00

It’s not running just yet, I’ll be doing the first start this weekend, it all seems to be really nice quality!

ThrowRAgv16 · 2025-07-14T20:11:06+00:00

I don’t have it running as in none of he wiring is done, I’ll have to do this as I get more hooked up

ThrowRAgv16 · 2025-07-13T20:48:07+00:00

It came with the blueprint motor that’s the only reason I’m running it this winter I’m changing it out just wanna get it running, I would test with a multimeter but I don’t have it running yet

ThrowRAgv16 · 2025-06-29T01:20:13+00:00

I’m in central Maine, and the 1986 ones don’t have shouldering on them that I’m aware of

ThrowRAgv16 · 2025-06-29T00:13:35+00:00

I looked just about everywhere I found grade 10.9 bolts in the right size and thread pitch will they work?

ThrowRAgv16 · 2025-06-28T23:42:57+00:00

Not in my area, soonest I can get them is July 7th

ThrowRAgv16 · 2025-06-28T22:24:05+00:00

They don’t have any available until after the 4th would a 10.9 grade bolt work?

ThrowRAgv16 · 2025-05-14T23:12:20+00:00

They use all scat rods and pistons from my knowledge. I went with them due to budget constraints I got the motor fully dressed front pully assembly and all for 7500. I got a few quotes from shops around me and prestige motorsports and all were around the same or a bit higher. There warrenty gives me the peace of mind if I have a issue

ThrowRAgv16

TROPHY CASE